Hostname: page-component-cb9f654ff-w5vf4 Total loading time: 0 Render date: 2025-08-29T20:14:09.438Z Has data issue: false hasContentIssue false
  • English
  • Français

Fdtd Simulations And Analysis Of Thin Sample Dielectric Properties Measurements Using Coaxial Probes

Published online by Cambridge University Press:  10 February 2011

S. Bringhurst ,
M. F. Iskander  and
M. J White
S. Bringhurst
Affiliation:
Electrical Engineering Department, University of Utah, Salt Lake City, UT 84112
M. F. Iskander
Affiliation:
Electrical Engineering Department, University of Utah, Salt Lake City, UT 84112
M. J White
Affiliation:
Electrical Engineering Department, University of Utah, Salt Lake City, UT 84112
Get access

Abstract

A metallized ceramic probe has been designed for high temperature broadband dielectric properties measurements. The probe was fabricated out of an alumina tube and rod as the outer and inner conductors respectively. The alumina was metallized with a 3 mil layer of moly-manganese and then covered with a 0.5 mil protective layer of nickel plating. The probe has been used to make complex dielectric properties measurements over the complete frequency band from 500 MHz to 3 GHz, and for temperatures as high as 1000 °C.

Information

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 430: Symposium O – Microwave Processing of Materials V , 1996 , 237
Copyright
Copyright © Materials Research Society 1996

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable

References

[1] Baker-Jarvis, J., Janezic, M. D., Domich, P. D., and Geyer, R. G., “Analysis of an open-ended coaxial probe with lift-off for nondestructive testing,” IEEE Trans. Instrum. Meas., Vol.43, pp. 711–718, 1994.Google Scholar
[2] Burdette, E. C., Cain, F. L., and Seals, J., “In vivo probe measurement technique for determining dielectric properties at VHF through microwave frequencies,” IEEE Trans., MTT-28, pp. 414–427, 1980.Google Scholar
[3] Andrade, O. M., Iskander, M. F., and Bringhurst, S., “High temperature broadband dielectric properties measurement techniques,” Microwave Processing of Materials III, MRS Vol.269, pp. 527–539, 1992.Google Scholar
[4] Li, C. L. and Chen, K. M., “Determination of electromagnetic properties of materials using flanged open-ended coaxial probe - full-wave analysis,” IEEE Trans. Instrum. Meas., Vol.44, pp. 19–27, 1995.Google Scholar
[5] De Langhe, P., Blomme, K., Martens, L., and Zutter, D. De, “Measurement of low-permittivity materials based on a spectral-domain analysis for the open-ended coaxial probe,” IEEE Trans. Instrum. Meas., Vol. 42, pp. 879–886, 1993.Google Scholar
[6] Iskander, M. F. and Dubow, J. B., “Time- and frequency-domain techniques for measuring the dielectric properties of rocks: a review,” Journal of Microwave Power,18(1), pp. 55–74, 1983.Google Scholar
[7] Bringhurst, S. and Iskander, M. F., “Open-ended metallized ceramic coaxial probe for high temperature dielectric properties measurements,” IEEE Trans. Micro. Theory. Tech., accepted for publication.Google Scholar
[8] Bringhurst, S., Andrade, O. M., and Iskander, M. F., “High-temperature dielectric properties measurements of ceramics,” Microwave Processing of Materials III, MRS Vol.269, pp. 561–568, 1992.Google Scholar
[9] Balanis, C. A., Advanced Engineering Electromagnetics, p. 79, (John Wiley & Sons, Inc., 1989)Google Scholar