Hostname: page-component-7c8c6479df-ph5wq Total loading time: 0 Render date: 2024-03-29T14:37:09.296Z Has data issue: false hasContentIssue false

Influence of Preparation Method and Molecular parameters on the Rheology of Model PEO/ Laponite Nanocomposites

Published online by Cambridge University Press:  24 May 2011

Jesmy Jose
Affiliation:
Polymères, Colloïdes, Interfaces, UMR CNRS 6120, Université du Maine Avenue Olivier Messiaen, 72085 Le Mans Cedex, France
Abakar Adam Omar
Affiliation:
Polymères, Colloïdes, Interfaces, UMR CNRS 6120, Université du Maine Avenue Olivier Messiaen, 72085 Le Mans Cedex, France
Guillaume Brotons
Affiliation:
Laboratoire de Physique de l’Etat Condensé, UMR CNRS 6087, Université du Maine Avenue Olivier Messiaen, 72085 Le Mans Cedex, France
Jean-François Tassin
Affiliation:
Polymères, Colloïdes, Interfaces, UMR CNRS 6120, Université du Maine Avenue Olivier Messiaen, 72085 Le Mans Cedex, France
Get access

Abstract

Model polymer nanocomposites based on geometrically well defined and protected Laponite particles dispersed in Poly(ethylene oxide) were investigated in order to improve the understanding of the filler dispersion effects on rheology by varying two experimental factors, namely preparation method and PEO matrix molecular weight. Preparation methods are divided into a solution dispersion and a melt dispersion by twin screw extrusion. The linear viscoelastic properties of the samples prepared by solution method revealed an elastic solid like behaviour at Laponite weight fractions as low as 0.1%, dramatically lower than the percolation threshold so far reported for such kind of systems. The sample preparation by melt dispersion, although leading to dispersed particles, does not achieve the same levels of modulus as compared to solution prepared mixtures. We propose a qualitative interpretation of this phenomenon, based on the mixture between a liquid and a dispersed phase of rather solid character. Further experiments using small angle X-ray scattering techniques (SAXS) show that the modulus level is not necessarily related to the height of the correlation peak characteristic of the Laponite stacks. However, for samples prepared with varying PEO matrix molecular weight the fraction of Laponite stacks decreases with increasing PEO molecular weight. The rheology master curve analyses show that confinements of polymer chains arising from high concentrations of particles and high molecular weight matrix chains do not impact the level of the low frequency modulus. However, a slower polymer dynamics, as observed for higher molecular weights, leads to an increase of the modulus at low particle loadings.

Type
Research Article
Copyright
Copyright © Materials Research Society 2011

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

[1] Kim, H. and Macosko, C. W., “Morphology and properties of polyester/exfoliated graphite nanocomposites,” Macromolecules, vol. 41, pp. 33173327, May 2008.Google Scholar
[2] Kim, H., et al. , “Graphene/Polymer Nanocomposites,” Macromolecules, vol. 43, pp. 65156530, Aug 24 2010.Google Scholar
[3] Giannelis, E. P., et al. , “Polymer-silicate nanocomposites: Model systems for confined polymers and polymer brushes,” Polymers in Confined Environments, vol. 138, pp. 107147, 1999.Google Scholar
[4] Moniruzzaman, M. and Winey, K. I., “Polymer nanocomposites containing carbon nanotubes,” Macromolecules, vol. 39, pp. 51945205, Aug 8 2006.Google Scholar
[5] Alexandre, M. and Dubois, P., “Polymer-layered silicate nanocomposites: preparation, properties and uses of a new class of materials,” Materials Science & Engineering R-Reports, vol. 28, pp. 163, Jun 15 2000.Google Scholar
[6] Cheng, S. Z. D., et al. , “Nonintegral and Integral Folding Crystal-Growth in Low-Molecular Mass Poly(Ethylene Oxide) Fractions .2. End-Group Effect - Alpha, Omega-Methoxy-Poly(Ethylene Oxide),” Journal of Polymer Science Part B-Polymer Physics, vol. 29, pp. 299310, Mar 15 1991.Google Scholar
[7] Cheng, S. Z. D., et al. , “Isothermal thickening and thinning processes in low molecular weight poly(ethylene oxide) fractions crystallized from the melt: 2. Crystals involving more than one fold,” Polymer, vol. 33, pp. 11401149, 1992.Google Scholar
[8] Cheng, S. Z. D., et al. , “Isothermal Thickening and Thinning Processes in Low-Molecular-Weight Poly(Ethylene Oxide) Fractions .1. From Nonintegral-Folding to Integral-Folding Chain Crystal Transitions,” Macromolecules, vol. 24, pp. 39373944, Jun 24 1991.Google Scholar
[9] Trappe, V. and Weitz, D. A., “Scaling of the viscoelasticity of weakly attractive particles,” Physical Review Letters, vol. 85, pp. 449452, Jul 2000.Google Scholar
[10] Loiseau, A. and Tassin, J. F., “Model nanocomposites based on laponite and poly(ethylene oxide): Preparation and rheology,” Macromolecules, vol. 39, pp. 91859191, Dec 26 2006.Google Scholar