Hostname: page-component-76fb5796d-25wd4 Total loading time: 0 Render date: 2024-04-26T18:55:37.839Z Has data issue: false hasContentIssue false
  • English
  • Français

Investigation of a Nanoporous Gold / TiO2 Catalyst by Electron Microscopy and Tomography

Published online by Cambridge University Press:  22 February 2013

Kristian Frank ,
Andre Wichmann ,
Arne Wittstock ,
Marcus Bäumer ,
Lutz Mädler  and
Andreas Rosenauer
Kristian Frank
Affiliation:
Institute of Solid State Physics, University of Bremen, Otto-Hahn-Allee 1, 28359 Bremen, Germany
Andre Wichmann
Affiliation:
Institute of Applied and Physical Chemistry, University of Bremen, Leobener Str. NW2, 28359 Bremen, Germany
Arne Wittstock
Affiliation:
Institute of Applied and Physical Chemistry, University of Bremen, Leobener Str. NW2, 28359 Bremen, Germany
Marcus Bäumer
Affiliation:
Institute of Applied and Physical Chemistry, University of Bremen, Leobener Str. NW2, 28359 Bremen, Germany
Lutz Mädler
Affiliation:
IWT Foundation Institute of Materials Science, University of Bremen, Badgassteiner Str. 3, 28359 Bremen, Germany
Andreas Rosenauer
Affiliation:
Institute of Solid State Physics, University of Bremen, Otto-Hahn-Allee 1, 28359 Bremen, Germany
Get access

Abstract

Nanoporous gold is a material with many possible applications e.g. in catalysts, sensors and electrode materials. We studied the functionalization of the nanoporous gold with TiO2 particles. Aiming at the low temperature oxidation of CO, the nanoporous gold can be coated with TiO2 in order to enhance catalytic activity. Structure and distribution of the TiO2 on the gold surface are important structural features, which were investigated by transmission electron microscopy. The preparation of the porous gold was tested with focused ion beam - preparation, conventional Ar+ ion beam preparation of nanoporous gold embedded in epoxy and ultramicrotome preparation of nanoporous gold embedded in epoxy. Considering the beam damage on the structure and the contamination of the surface, ultramicrotome preparation turned out to be the best solution. It was shown, that the gold ligaments are abundantly covered by approximately 5 nm TiO2 particles. The determination of the largest lattice fringe distance in high resolution mode revealed that the crystalline nanoparticles consist of the anatase phase. The spatial Ti distribution was measured with energy filtered transmission electron microscopy. Scanning transmission electron microscopy tomography was applied to reconstruct the three-dimensional structure of the gold coated with TiO2 particles.

Keywords

AuTiscanning transmission electron microscopy (STEM)
Type
Articles
Information
MRS Online Proceedings Library (OPL) , Volume 1504: Symposium V – Geometry and Topology of Biomolecular and Functional Nanomaterials , 2013 , mrsf12-1504-v08-07
Copyright
Copyright © Materials Research Society 2013

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

Zielasek, V., Jürgens, B., Schulz, C., Biener, J., Biener, M. M., Hamza, A. V. and Bäumer, M.. Angw. Chem. 118 (2006), 8421–8425 CrossRefGoogle Scholar
Wichmann, A. et al. . Accepted by ChemCatChem. DOI: 10.1002/cctc.201200759 CrossRefGoogle Scholar
Gilbert, P.. Proc. R. Soc. Lond. B. 182 (1972), 89–102 Google Scholar
Gilbert, P.. J. Theor. Biol. 36 (1972), 105–117 CrossRefGoogle Scholar
Wen, P., Tao, Z., Ishikawa, Y., Itoh, H. and Feng, Q.. Appl. Phys. Lett. 97 (2010), 131906 CrossRefGoogle Scholar
Van den Broek, W., Rosenauer, A., Goris, B., Martinez, A.G.T., Bals, S., Van Aert, S. and Van Dyck, D.. Ultramicroscopy 116 (2012), 8–12 CrossRefGoogle Scholar