Hostname: page-component-7c8c6479df-94d59 Total loading time: 0 Render date: 2024-03-28T09:39:57.339Z Has data issue: false hasContentIssue false

A New Theory for the Debonding of Discontinuous Fibers in an Elastic Matrix

Published online by Cambridge University Press:  21 February 2011

Christopher K. Y. Leung
Affiliation:
Department of Civil Engineering, Massachusetts Institute of Technology, Cambridge, MA 02139
Victor C. Li
Affiliation:
Department of Civil Engineering, Massachusetts Institute of Technology, Cambridge, MA 02139
Get access

Abstract

The mechanical properties of fiber composites are strongly influenced by the debonding of fibers. When an embedded fiber is loaded from one end, debonding can occur at both the loaded end and the embedded end. Existing theories neglect the possibility of debonding from the embedded end and are thus limited in applications to cases with low fiber volume fraction, low fiber modulus, high interfacial strength/interfacial friction ratio or short fiber length. A new twoway fiber debonding theory, which can extend the validity of one-way debonding theories to all general cases, has recently been developed. In this paper, the physical reason for the occurrence of two-way debonding is discussed. The limit of validity for one-way debonding theories is considered. One-way and two-way debonding theories are then compared with respect to the prediction of composite behaviour. The determination of interfacial parameters from the fiber pull-out test will also be described.

Type
Research Article
Copyright
Copyright © Materials Research Society 1990

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Marshall, D.B., Cox, B.N. & Evans, A.G., “The Mechanics of Matrix Cracking in Brittle- Matrix Fiber Composites”, Acta Metall. Vol 33, No 11, p.20132021 (1985)Google Scholar
2. Majumdar, B.S., Newaz, G.M. and Rosenfield, A.R., “Yielding Behavior of Ceramic Matrix Composites”, Proceedings of the Seventh International Conference on Fracture, Vc 4, p.2805–2814 (1989)Google Scholar
3. Leung, C.K.Y. and Li, V.C., “A New Strength-Based Model for the Debonding of Discontinuous Fibers in an Elastic Matrix”, submitted to J. Mat. Sci. (1989)Google Scholar
4. Leung, C.K.Y. and Li, V.C., “Applications of a Two-Way Debonding Theory to Short Fiber Composites”, submitted to Composites (1989)Google Scholar
5. Greszczuk, L.B., “Theoretical Studies of the Mechanics of the Fiber-Matrix Interface in Composites”, ASTM STP 452, p. 4258 (1969)Google Scholar
6. Takaku, A. and Arridge, R.G.C., “The Effect of Interfacial Radial and Shear Stress on Fiber Pull-out in Composite Materials”, J. Phys. D: Appl. Phys., Vol.6, p.20382047 (1973).Google Scholar
7. Lawrence, P., “Some Theoretical Considerations of Fiber Pull-out from an Elastic Matrix”, J. Mat.Sci., Vol.7, p. 16 (1972)Google Scholar
8. Gopalaratnam, V.S. and Shah, S.P., “Tensile Fracture of Steel Fiber Reinforced Concrete”, ASCE J. Eng. Mech., Vol.113, No.5, p. 635653 (1987)Google Scholar