Hostname: page-component-cb9f654ff-w5vf4 Total loading time: 0 Render date: 2025-08-31T09:58:45.016Z Has data issue: false hasContentIssue false
  • English
  • Français

Testing Fly Ash for Fineness to ASTM C 430: Sieve Calibration

Published online by Cambridge University Press:  21 February 2011

W. Barry Butler  and
Howard M. Kanare
W. Barry Butler
Affiliation:
Amatek Limited, Villawood, Australia
Howard M. Kanare
Affiliation:
Construction Technology Laboratories Inc., Skokie, Illinois
Get access

Abstract

Following dissatisfaction with the existing calibration factor for standard fly ash used in Australia to AS 1129–1971, “Fly Ash for Use in Concrete,” a joint investigation was made by Amatek Limited and Construction Technology Laboratories Inc. Test results for five reference materials and two Australian fly ashes from tests to ASTM C 430 on both electroformed and woven wire sieves were examined and “corrected” by several means.

The ASTM standard method of sieve correction is challenged, both in the use of Standard Reference Material (SRM) cement and the basis of sieve correction for coarse samples. Preferred bases of correction are suggested.

Information

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 136: Symposium O – Fly Ash and Coal Conversion By-Products V , 1988 , 107
Copyright
Copyright © Materials Research Society 1989

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable

References

REFERENCES

1. Butler, W.B., Concrete (U.K.), Dec. 1985, pp. 12–14.Google Scholar
2. Kanare, H.M., Final Quarter Progress Report Contract NB 83 SBCA 2029 (CR 7779–4330), P.C.A. Construction Technology Laboratories, May 1986.Google Scholar