Hostname: page-component-848d4c4894-p2v8j Total loading time: 0.001 Render date: 2024-05-16T02:16:37.096Z Has data issue: false hasContentIssue false
  • English
  • Français

YBCO-Based Multilayer Structures on Large-Area Substrates

Published online by Cambridge University Press:  26 February 2011

J. R. Gavaler  and
J. Talvacchio
J. R. Gavaler
Affiliation:
Westinghouse STC, 1310 Beulah Road, Pittsburgh, PA 15235
J. Talvacchio
Affiliation:
Westinghouse STC, 1310 Beulah Road, Pittsburgh, PA 15235
Get access

Abstract

We have deposited YBa2Cu3O7 (YBCO) films on LaAlO3 substrates up to two inches in diameter using 90° off-axis magnetron sputtering from a single stoichiometric target. With this same method, epitaxial bilayers and trilayers of insulating SrTiO3, LaAlO3, MgO, metallic PrBa2Cu3O7 (PrBCO), or superconducting La2−xSrxCuO4 (LSCO) were deposited in combinations with YBCO. In the resulting structures with c-axis orientations, the YBCO had Tc's of 90K or higher over the entire surface area. Maximum resistivity values of 6 × 109 Ω-cm in YBCO/insulator/YBCO structures were obtained in vertical transport measurements with SrTiO3. An important cause for degraded electrical properties in the structures incorporating epitaxial insulators was the presence of copper oxide particles on the YBCO surface. Methods used to minimize the number of these particles are discussed.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 275: Symposium S – Layered Superconductors: Fabrication, Properties and Applications , 1992 , 305
Copyright
Copyright © Materials Research Society 1992

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Kingston, J. J., Wellstood, F. C., Lerch, P., Miklich, A. H., and Clarke, J., “Multilayer YBa2Cu3Ox-SrTiO3-YBa2Cu3Ox Films for Insulating Crossovers”, Appl. Phys. Lett. 56(2), 189–191 (1990).Google Scholar
2. Tonouchi, M., Yoshizako, Y., Iyori, M., and Kobayashi, T., “Double Heteroepitaxy of YBaCuO/MgO/YBaCuO System”, Proc. Int. Supercond. Elec. Cont. (Tokyo, 1989) p. 433.Google Scholar
3. Lee, A. E., Burch, J. F., Simon, R. W., Luine, J. A., Hu, R., and Schwarzbek, S. M., “LaAlO3-YBCO Multilayers”, IEEE Trans. Magn. 27(2), 1365 (1991).Google Scholar
4. Talvacchio, J., Forrester, M. G., Gavaler, J. R., and Braggins, T. T., “YBCO and LSCO Films Grown by Off-Axis Sputtering”, in Science and Technology of Thin Film Superconductors II, edited by McConnell, R. and Wolf, S. A. (Plenum, New York, 1990).Google Scholar
5. Eibl, O., Hoenig, H. E., Triscone, J. M., Fischer, O., Antognazza, L., and Brunner, O., “Microstructure of YBa2Cu3O7/PrBa2Cu3O7 Superlattices Deposited on (100) SrTiO3 Single Crystals”, Physica C 172, 365–372 (1990).Google Scholar
6. Inam, A., Rogers, C. T., Ramesh, R., Remschnig, K., Farrow, L., Hart, D., Venkatesan, T., and Wilkens, B., “A-Axis Oriented Epitaxial YBa2Cu3O7−x-PrBa2Cu3O7-y Heterostructures”, Appl. Phys. Lett. 57(23), 2484 (1990).Google Scholar
7. Gavaler, J. R., Talvacchio, J., Braggins, T. T., and Forrester, M. G., “Critical Parameters in the Single-Target Sputtering of YBCO”, J. Appl. Phys. 70, 4383 (1991).Google Scholar
8. Braggins, T. T., Gavaler, J. R., and Talvacchio, J., “In-Situ Deposition of YBaCuO Films on Both Sides of Two-Inch-Diameter Wafers by Off-Axis Sputtering”, accepted for publication in Proc. ICMC, Advances in Cryogenic Engineering (Materials), (Plenum, New York, 1992).Google Scholar
9. Raistrick, I. D., Hawley, M., Beery, J. G., Garzon, F. H., and Houlton, R. J., “Microstructure and Growth Mechanism of Thin Sputtered Films of YBa2Cu3O7 on MgO Substrates”, Appl. Phys. Lett. 59(24), 3177 (1991).Google Scholar