Introduction

Recent studies on selected area growth (SAG) and lateral epitaxial overgrowth (LEO) of GaN structures on 6H-SiC [Reference Nam, Bremser, Ward, Nemanich and Davis1-Reference Zheleva, Nam, Ashmawi, Griffin and Davis6] and Sapphire [Reference Usui, Sunakawa, Sakai and Jamaguchi7-Reference Zhong, Johnson, McNulty, Brown, Cook and Schezina10] have shown that the laterally overgrown regions have four-to-five orders of magnitude lower densities of dislocations compared to the regions of vertical growth. During the selective growth the GaN structure grows vertically and laterally at the same time, but the vertical growth dominates during the growth from the windows in SiO₂ (i.e. the growth rate of (0001) planes of GaN is higher than the growth rate of the GaN side facets), while the lateral growth dominates during the GaN growth over the SiO₂ (i.e. the growth rate of the GaN side facets is higher than the growth rate of the (0001) planes). Thus, the reduction in the defect density is associated with the change in the growth direction from vertical during the initial stages of growth from the openings in the SiO₂, to lateral over the SiO₂ in the subsequent stages of the lateral epitaxial overgrowth. Our previous studies on the development of the side facets morphology of the LEO-GaN as a function of the growth time [Reference Nam, Zheleva, Bremser and Davis5,Reference Zheleva, Nam, Ashmawi, Griffin and Davis6], pointed that while the crystallographic template for the conventional vertical growth are the (0001) GaN faces, the crystallographic template for the lateral overgrowth are either the vertical {11

0} side facets if the SiO₂ stripes are oriented along <100> direction, or the 62° inclined {101} facets when the stripe edges are oriented along <1100> direction, see the schematics in Fig.1. However, if the crystallographic template for the lateral overgrowth are the side GaN facets, then lateral growth would be possible even without a SiO_{2 mask} . Then, a question rises: how to eliminate the SiO₂ mask and still to preserve the crystallographic templates for the vertical growth (the (0001) planes) as well as the crystallographic templates for the lateral growth - the side facets, {110} or the {101} planes, depending on the stripe orientation? The new approach for lateral growth of nearly defect free GaN structures, namely pendeo -epitaxy is an answer to the above question [Reference Zheleva, Smith, Thomson, Linthicum and Davis11].

Figure 1.

A schematic of the development of the side facet morphology of LEO-GaN structure as a function of the growth time in [1

00] orientation of the SiO₂ stripes. The vertical {11

0} side facets are the crystallographic templates for the lateral growth.

Experiment

The new technique, namely, pendeo-epitaxy has been developed and employed for the lateral growth of GaN films from the side walls of sequential and parallel GaN columns [Reference Zheleva, Smith, Thomson, Linthicum and Davis11]. An alternative approach employed in the present research to achieve lateral and vertical epitaxy of GaN is comprised of the deposition of this material upon an aligned series of <1

00> oriented columns or wells of GaN having the vertical {110} side facets, as shown schematically in Fig.2.

Figure 2.

A schematic of the new process route for the pendeo-epitaxial growth of GaN layered structures. The PE-GaN growth includes the following major steps: (a) growth of a GaN layer on a AlN/6H-SiC substrate, (b) selective etching to form the side walls in the alternating GaN/AlN/substrate columns and trenches (wells), and (c) growth of the pendeo-epitaxial GaN layer before the coalescence.

The pendeo-epitaxial approach involves three major process steps: (i) growth of the underlying (seed) GaN layer on a suitable substrate, (ii) selective etching through a Ni mask [Reference Smith, Wolden, Bremser, Hanser, Davis and Lampert12] to form alternating GaN/AlN/substrate columns and trenches in the substrate, and (iii) growth of the pendeo-epitaxial GaN layer. No amorphous mask over the GaN seed layer is employed to support the laterally grown material and to separate it from a crystallographic surface. Thus, the lateral component of the GaN film grows free standing from the side walls of the columns into and over the etched trenches, as shown in Fig. 2(c). This laterally grown material does not make contact with the bottom surfaces of the trenches. As such, the term pendeo - (from the Latin “hangs on” or “suspends from”) epitaxy was proposed to describe this process route [Reference Zheleva, Smith, Thomson, Linthicum and Davis11]. Thus pendeo-epitaxy (PE), or the lateral growth from sidewalls of GaN posts into and over trenches provides an alternative process route to the conventional LEO technique, for growth of defect free GaN layers.

The side faces - crystallographic templates for the PE-GaN are prepared via etching of trenches (wells) or columns (posts), which include multiple sidewalls in the u-GaN/AlN/6H-SiC substrate-heterostructure. To form the columns and the trenches a dry etching technique with Cl₂ and Ar as process gasses, and Ni mask in inductively coupled plasma (ICP) system were utilized. Details of the dry plasma etching parameters of GaN related with the etch rates and selectivities as a function of the ICP power, dc bias, the gases pressure and flow rates, as well as gases percentages have been previously investigated [Reference Smith, Wolden, Bremser, Hanser, Davis and Lampert12]. The PE-GaN growth was performed via metalorganic vapor phase epitaxy (MOVPE) using triethylgallium (TEG) and ammonia ^(NH ₃) precursors, at 1080°C and 45 Torr. The TEG at 26 µmol/min and NH3 at 1500 sccm were used in combination with 3000 sccm H2 diluent. The morphology and microstructure of the pendeo-epitaxial GaN films was studied with scanning electron microscopy (SEM-JEOL 6400-FE); and transmission electron microscopy (TEM-TOPCON 002B).

Results and Discussion

Two modes of initiation of the pendeo-epitaxial GaN growth via MOVPE were observed, as shown schematically in Fig. 3, and pictorially in Fig. 4 (a-d): Mode A - promoting the lateral growth of the {11

0} side facets into the wells faster than the vertical growth of the (0001) top facets; and Mode B - enabling the top (0001) faces to grow initially faster followed by the pendeo-epitaxial growth over the wells from the newly formed {110} side facets. SEM studies revealed that the coalesced regions are either defect-free or sometimes exhibit voids. Above these voids the PE-GaN material is usually defect free. Preliminary SEM and TEM studies reveal four-to-five times larger lateral growth rates of the PE-GaN compared to the growth rates for the LEO-GaN for a similar geometry. Studies with AFM revealed atomically flat top and side surfaces for the PE-GaN material.A four-to-five order decrease in the dislocation density in the pendeo-epitaxial GaN relative to that in the GaN columns (dislocation density ∼10⁹cm⁻²) was observed via TEM. TEM observations revealed that in pendeo-epitaxial GaN films the dislocations do not propagate laterally from the GaN columns when the structure grows laterally from the side walls into and over the trenches. The regions of coalescence of the pendeoepitaxial GaN structures are usually defect free above the voids.

Figure 3.

A schematic of the pendeo-epitaxial GaN growth in (a) Mode A and (b) Mode B.

Figure 4.

SEM (a) and TEM (b) micrographs of PE-GaN growth in Mode A; SEM (c) and TEM (d) of PE-GaN growth in Mode B.

Occasionally both growth modes are observed in a same column, i.e. on one side of the column - Mode A, and on the other side of the same column - Mode B. Our experiments revealed that slightly higher growth temperatures enhance the pendeo-epitaxial lateral growth from the side faces - Mode A. Thus differences in the morphology of the PE-GaN which appear as two different growth modes at same growth conditions are attributed to the fluctuations in the growth parameters as temperature and TEG flow rate, thus changing the diffusion characteristics. This suggests that there is a very narrow energy threshold associated with the parameters of the growth kinetics as mean free path and average life times until adsorption and incorporation of the adatoms, which enhances the growth either along [11

0] (Mode A), or along [0001] Mode B. Preliminary studies of the accommodation of the thermal stress in the PE-GaN structures reveal five-to-ten times reduction in the thermal stress compared to similar geometries of LEO-GaN structures.

Application of the pendeo-epitaxial growth technique in combination with a silicon nitride mask layer capping the seed GaN columns before the PE-GaN growth helps to achieve a continuous GaN layer of very low defects density within a single lithography step (see K. Linthicum et all., D. Thomson et all., and T. Gehrke et all., this volume).

Summary

A new technique - pendeo-epitaxy has been developed and employed for the lateral growth of GaN films from the side walls of sequential and parallel GaN columns. The new approach for the pendeo-epitaxial growth of GaN layered structures involves the following major stages: (a) growth of a GaN layer on a suitable substrate; (b) selective etching through a mask to form alternating GaN/AlN/substrate columns and trenches in the substrate, and (c) growth of the pendeo-epitaxial GaN layer. The pendeo-epitaxial GaN growth revealed two modes of growth at similar growth conditions: Mode A: PE-GaN growth from the side {11

0} walls of the GaN/AlN/substrate column into and over the wells, and Mode B: PE-GaN growth initiated from the (0001) planes followed by the lateral growth over the wells. Differences in the morphology of the PE-GaN layers are attributed to the fluctuations in the growth parameters as temperature and TEG flow rate, thus changing the diffusion characteristics. TEM studies revealed that the laterally grown regions exhibit four-to-five times lower dislocation density, compared to the regions within the GaN column and these defects do not propagate laterally into the PE-GaN regions. SEM and TEM studies revealed four-to-five times larger lateral growth rates of the PE-GaN compared to the growth rates for the LEO-GaN for a similar geometry.