The weathering of eastern Australian basalts, sampled from the rounded, hard, core-stone to the rind of softer weathered material, has been examined by bulk chemical analyses, thin section petrography, electron microprobe, and X-ray powder diffraction analyses. Using density as a measure of weathering intensity, data from four core-stones show that at a stage of weathering in which the total loss due to dissolution is – (i.e., at the core-stone rim), the percentages lost of the following major elements are: Ca, 85; Mg, 80; Na, 70; K, 50–80; P, 55; Si, 45; Mn, 40; Al, 5; Fe, 0; and Ti, 0. With more intense weathering, deposition of some elements, particularly rare earths and Ba, and mobilization and deposition of Al and Fe make quantification impossible. The rate of weathering of individual minerals is consistent with the well-known susceptibility series: glass ∼ olivine > plagioclase > pyroxene > opaque minerals. Clay minerals in the core-stones are dominated by smectites, whereas those in the surrounding more intensely weathered rinds are dominated by halloysite and goethite.

The 57Fe Mössbauer spectra of an iron-rich montmorillonite, an illite, and two glauconites were measured and computer-fitted with appropriate Fe3+ and Fe2+ doublet resonances. The broad experimental Fe3+ resonance of montmorillonite probably arises from Fe3+ in the octahedral sites and a trans-arrangement of OH groups; however, a large variation in the neighboring environment of these sites exists. In illite this Fe3+ resonance is similar but shows less broadening; it arises from Fe3+ located predominantly in trans-OH octahedral sites, with some Fe3+ being located in cis-OH octahedral sites. Because of the increased iron content less variation exists, compared with montmorillonite, in the neighboring octahedral sites. The Fe3+ resonance is narrower still for the glauconites and represents Fe3+ substituting primarily into cis-OH octahedral sites, similar to that previously reported for nontronite.

The tetrahedral Fe3+ content is very low for montmorillonite and increases progressively for illite and glauconite, suggesting that a higher tetrahedral Fe3+ content directs Fe3+ in the octahedral layer into cis-OH sites. In montmorillonite, the Fe2+ is located only in trans-OH sites; in illite Fe2+ is largely in trans-OH sites and only slightly in cis-OH sites; and in glauconite, Fe2+ is located largely in cis-OH sites and only slightly in trans-OH sites. These assignments suggest that for Fe2-, the doublet with the larger quadrupole interaction arises from Fe2+ in trans-OH sites and the doublet with the smaller quadrupole interaction, from Fe2+ in cis-OH sites.

If anilinium ions are intercalated into Llano vermiculite, the stacking order of adjacent silicate layers is increased, resulting in a relatively sharp single crystal X-ray diffraction (XRD) pattern. The packing of intercalated organic members forms a superstructure and produces bonding from layer to layer which favors the stacking order. Superlattice reflections occur which, although sharp in the a*b* plane, are streaked along c*. Apparently there is little coherence between adjacent layers of ordered organic units.

A three-dimensional set of XRD reflections for a triclinic sub-cell having the following lattice parameters was measured: a = 5.326(3), b = 9.264(4), c = 14.82(5) Å, α = 90.31(7), β = 96.70(6), and γ = 89.55(5)°. In this unit cell (symmetry Cl), ditrigonal cavities in adjacent silicate layers are approximately opposite. Differential Fourier analyses and least-squares refinements showed that the principal axes of the anilinium ions, i.e., N-C(1)-C(4), are nearly perpendicular to the silicate layers. The planes of the aromatic rings, however, are about ±30° to X, neither parallel nor perpendicular to that direction, as indicated by earlier studies.

Inorganic cations and water molecules are also present in the interlayer; the former and some of the latter occupy sites near the middle of the layer. Anilinium-rich and anilinium-poor domains coexist. In the latter, the cation-water system predominates and apparently conforms to the superstructure. Although the cation-water structure could not be uniquely established from the reflections produced by the sub-cell, possible positional coordinates were obtained. From structural data for the silicate layers, no evidence was found for long-range Si/Al ordering in the tetrahedral sites.

The coarse (0.4–2 µm) clay fraction of an Albian black shale collected in the Atlantic Ocean (Deep Sea Drilling Project leg 11) consists chiefly (90–95%) of smectite and 5–10% illite. Both minerals are locally surrounded by overgrowth structures, such as fine laths about 0.05–0.4 µm long and 0.02–0.1 µm wide. Individual laths or assemblages of laths protrude from the center of smectite flakes at angles of about 60° to each other. Laths occur around illite crystals in a similar manner or coalesce into a rim that consists of 0.05–0.1-µm-size particles. On the basis of scanning transmission electron microscopy: (1) the center of individual illite crystals consists of a dioctahedral mineral, but the overgrowth structures are Al-Fe beidellites; and (2) the smectite flakes have highly variable compositions, but correspond chiefly to Fe-Al-beidellite, whereas the overgrowths are compositionally close to montmorillonite.

The overgrowth structures seem to have formed during early diagenesis. The chemical composition of overgrowths around illite and smectite tend to be similar in response to the new environment, implying an addition of silica to both materials.

An end-member natroalunite of composition (K0.04Na0.96)(Al2.98Fe0.02)(SO4)2(OH)6 occurs in saprolitic clays in a laterite profile developed over Deccan Trap basalts at Matanumad in the Kutch region of Gujarath state, India. Pseudocubic natroalunite crystals, ranging from 0.5 to 1 µm in size, have replaced pseudohexagonal, 2-µm-size platelets of kaolinite. The reverse reaction (kaolinization of natroalunite) has also been observed in the laterites and bauxites immediately adjacent to the saprolite. The kaolinite crystallites that replaced natroalunite occur as a mosaic of anhedral platelets that range in size from 0.1 to 0.3 µm. The formation of natroalunite at Matanumad postdates the laterization of the basalts. It is related to the post-diagenetic formation of sulfuric acid-rich solutions by the oxidation of pyrite in the Eocene-Oligocene black shales of the Matanumad basin. The kaolinitic clays at the top of the saprolite zone have been intensely altered by the acidic solutions, leading to a high concentration of natroalunite.

57Fe Mössbauer spectra obtained at room temperature and 78 K for natural Mg-saturated, Ca-saturated, and benzidinium-intercalated vermiculite having a high tetrahedral iron content are presented. For all samples the spectra were computer-fitted with five overlapping doublets, representing Fe in both tetrahedral and octahedral sites. One doublet has parameters consistent with the weathered ilmenite known to be present as inclusions. For the intercalated vermiculite, the δ value of the doublet assigned to the tetrahedral Fe3+ increased with respect to the untreated sample, suggesting that the electron densities about the Fe sites had decreased following intercalation. A charge movement from the silicate layers towards the interlayer monovalent benzidinium ions is also implied. The direction of this charge movement is opposite to that found when blue monopositive radical cations form on montmorillonite surfaces. The Mössbauer evidence suggests the absence of an interlayer-Fe3+ complex.

Dimethylselenoxide (DMSeO) forms three structurally resolvable intercalates with kaolinite (d(001) = 10.95, 11.26, and 11.38 Å). The 11.26-Å kaolinite: DMSeO intercalate is structurally analogous to the 3-D ordered kaolinite: DMSO intercalate (d(001) = 11.22 Å). Infrared and solid-state 77Se nuclear magnetic resonance data indicate that all DMSeO molecules are equivalent in the structure and, therefore, that the 11.26-Å kaolinite: DMSeO intercalate structure is C-face centered. Structural model refinement from X-ray powder diffraction (XRD) data further support this conclusion (Pl, a = 5.195(2), b = 8.990(4), c = 11.946(5) Å, α = 91.33(2)°, β = 109.39(2)°, γ = 89.77(2)°). The kaolinite: DMSO intercalate structure was subsequently re-refined from the XRD profile in C-face centered Pl. The derived orientation of the DMSO and DMSeO molecules with respect to the basal plane of their respective intercalates is in agreement with polarized infrared measurements of the angles with ab of S=O (40.3°) and Se=O (38.8°) for the 11.26-Å intercalate. The locations of the organic molecules also agree with observed infrared band splittings and perturbations. Interatomic distances calculated from the band shifts agree with those for the XRD derived structures.

The 11.38-Å kaolinite: DMSeO intercalate is closely related to the 11.26-Å intercalate, the main differences being a 2-fold disorder in the orientation of the DMSeO molecule and less penetration of the kaolinite ditrigonal cavity by that molecule. The 10.95-Å kaolinite: DMSeO intercalate, displaying disorder parallel to [110], was obtained from the 11.26- or 11.38-Å intercalates by removal of some DMSeO.

The effect of pH on the flocculation-dispersion behavior of noncrystalline aluminum and iron oxides, kaolinite, montmorillonite, and various mixtures of these materials was investigated. The clays were Na- or Ca-saturated and freeze-dried before use. Critical coagulation concentrations (CCC) of all materials and mixtures were found to be pH dependent. The Al oxide was flocculated at pH >9.5 and the iron oxide was flocculated between pH 6.0 and 8.2; i.e., flocculation occurred at pHs near the point of zero charge (PZC). The CCC of both the Na- and Ca-clay systems increased with increasing pH. The effect of pH was greater for the Na-kaolinite (flocculated at pH 5.8 and having a CCC of 55 meq/liter at pH 9.1) than the Na-montmorillonite system (having a CCC of 14 meq/liter at pH 6.4 and a CCC of 28 meq/liter at pH 9.4). A 50/50 mixture of Na-kaolinite and Na-montmorillonite behaved more like montmorillonite (having CCCs of 13 and 33 meq/liter at pH 6.2 and pH 9.0, respectively). The presence of either noncrystalline oxide decreased the CCC over that of the clay(s) alone; the decrease occurred at pHs >7 for Al oxide and at pHs >6.5 for Fe oxide. Aluminum oxide produced a greater decrease in CCC than Fe oxide, especially at pHs >8. The effect of each oxide on CCC was greatest near the PZC, 9.5 and 7.2 for Al and Fe oxide, respectively.