Volume 60 - Issue 4 - August 2012
Article
First-Principles Molecular Dynamics Insight into Fe2+ Complexes Adsorbed on Edge Surfaces of Clay Minerals
- Xiandong Liu, Evert Jan Meijer, Xiancai Lu, Rucheng Wang
-
- Published online by Cambridge University Press:
- 01 January 2024, pp. 341-347
-
- Article
- Export citation
-
Using first-principles molecular-dynamics simulations, probable inner-sphere complexes of Fe2+ adsorbed on the edge surfaces of clay minerals were investigated. Ferrous ions are important reductants in natural processes and their properties can be altered significantly by complexation on edge surfaces of clay minerals. However, the microscopic picture of adsorption sites and structures of Fe2+ is difficult to reveal with modern experimental techniques and, therefore, remains unclear. From the results of first-principles molecular-dynamics simulations, evidence has been provided that complexes on ≡Si—O sites were the most stable forms, which should be responsible for the experimentally observed pH-dependent uptake. Such complexation was found to be strong enough to distort the local coordination structures of Si—O tetrahedra in the substrate. Analyses showed that Fe2+—Owater coordination structures were dominated by the solvent with surface groups participating in the complexes via H bonding. The present study provided a microscopic basis for understanding the chemical processes involving surface-complexed Fe2+ ions.
On the Problems of Total Specific Surface Area and Cation Exchange Capacity Measurements in Organic-Rich Sedimentary Rocks
- Arkadiusz Derkowski, Thomas F. Bristow
-
- Published online by Cambridge University Press:
- 01 January 2024, pp. 348-362
-
- Article
- Export citation
-
The increasing exploration and exploitation of hydrocarbon resources hosted by oil and gas shales demands the correct measurement of certain properties of sedimentary rocks rich in organic matter (OM). Two essential properties of OM-rich shales, the total specific surface area (TSSA) and cation exchange capacity (CEC), are primarily controlled by the rock’s clay mineral content (i.e. the type and quantity). This paper presents the limitations of two commonly used methods of measuring bulk-rock TSSA and CEC, ethylene glycol monoethyl ether (EGME) retention and visible light spectrometry of Co(III)-hexamine, in OM-rich rocks. The limitations were investigated using a suite of OM-rich shales and mudstones that vary in origin, age, clay mineral content, and thermal maturity.
Ethylene glycol monoethyl ether reacted strongly with and was retained by natural OM, producing excess TSSA if calculated using commonly applied adsorption coefficients. Although the intensity of the reaction seems to depend on thermal maturity, OM in all the samples analyzed reacted with EGME to an extent that made TSSA values unreliable; therefore, EGME is not recommended for TSSA measurements on samples containing >3% OM.
Some evidence indicated that drying at ⩾200°C may influence bulk-rock CEC values by altering OM in early mature rocks. In light of this evidence, drying at 110°C is recommended as a more suitable pretreatment for CEC measurements in OM-rich shales. When using visible light spectrometry for CEC determination, leachable sample components contributed to the absorbance of the measured wavelength (470 nm), decreasing the calculated bulk rock CEC value. A test of sample-derived excess absorbance with zero-absorbance solutions (i.e. NaCl) and the introduction of corrections to the CEC calculation are recommended.
Conformational Effects of Adsorbed Polymer on the Swelling Behavior of Engineered Clay Minerals
- Sungho Kim, Michael A. Motyka, Angelica M. Palomino, Nikolas J. Podraza
-
- Published online by Cambridge University Press:
- 01 January 2024, pp. 363-373
-
- Article
- Export citation
-
The conformational behavior of polymers in clay-polymer nanocomposites (CPN) is not fully understood because of the many factors involved. The purpose of the present study was to investigate the conformational behavior of a polymer at the micro- and meso-scales in order to predict the behavior of tunable CPN. The study used a pH-responsive polymer, polyacrylamide, which has time-dependent hydrolysis response properties, to examine micro-scale conformational behavior of the polymer adsorbed on representative clay-mineral surfaces, SiO2 and Al2O3. A nanocomposite and a microcomposite were used to link meso-scale CPN behavior to micro-scale polymer conformation. The conformational behavior was characterized using in situ, real-time spectroscopic ellipsometry. The contracted coil conformation of polyacrylamide was observed at pH = 3, while extended conformation was observed at pH = 11.5 on both SiO2 and Al2O3 surfaces. At pH = 11.5, the polymer conformation changed from expanded coil to extended conformation over time. The polymer conformation changed more rapidly with the Al2O3 surface due to mineral dissolution at pH = 3 and 11.5. Swelling tests were conducted as functions of pH and time to link the micro-scale phenomena to meso-scale CPN behavior. The results indicated that the swelling potential of CPN corresponded to the conformation of adsorbed polyacrylamide, which varied with pH and time. The swelling potential of CPN was maximized at pH = 11.5 and decreased with decreasing pH, corresponding to the observed micro-scale conformational behavior.
The Determinative Role of the Exchange Cation and Layer-Charge Density of Smectite on Aflatoxin Adsorption
- Youjun Deng, Lian Liu, Ana Luisa Barrientos Velázquez, Joe B. Dixon
-
- Published online by Cambridge University Press:
- 01 January 2024, pp. 374-386
-
- Article
- Export citation
-
Using bentonites to adsorb aflatoxin is an effective method of minimizing the toxicity of aflatoxin to animals and humans. Early studies indicated a more than 10-fold difference in aflatoxin adsorption capacity among different bentonites. The determining mineralogical and chemical properties of the clays in aflatoxin adsorption are still poorly understood. The objective of this study was to test the hypothesis that a bentonite’s selectivity and adsorption capacity for aflatoxin is mainly determined by the ‘size matching’ requirement, on a nm scale, between the non-polar interlayer surface domains and the aflatoxin molecules. The non-polar surface domain size of smectites was varied by (1) selecting smectites with different charge densities; and (2) changing the valence and the size of exchange cations to control the amount of water in the hydration shells of the cations. Infrared spectroscopy and X-ray diffraction were also used to characterize the aflatoxin-smectite complexes to investigate if layer-charge density would affect the bonding strength between aflatoxin and the minerals. A large aflatoxin adsorption capacity and high selectivity for aflatoxin were achieved by selecting smectites that had low charge density as represented by their <110 meq/100 g cation exchange capacity. An individual smectite’s selectivity and adsorption capacity for aflatoxin could be enhanced or weakened by replacing the exchange cation. When the smectite was saturated with divalent cations that have smaller hydrated radius (e.g. Ba2+), the smectite’s adsorption capacity and affinity for aflatoxin were enhanced. Aflatoxin entered the interlayer of all six smectites tested. The strength of its bonding to the smectites was not affected by the layer-charge density of the smectites. The results confirmed the importance of nm-scale polarity and size match between aflatoxin molecules and the adsorbing sites on smectite. The high selectivity for aflatoxin can be achieved by selecting a smectite with adequate charge density or by replacing the exchange cations with divalent cations that have low hydration energy.
Mineralogy of Egyptian Bentonitic Clays I: Discriminant Function Analysis
- Mohamed Agha, Ray E. Ferrell, George F. Hart
-
- Published online by Cambridge University Press:
- 01 January 2024, pp. 387-404
-
- Article
- Export citation
-
The purpose of the present investigation was to apply a discriminant function analysis (DFA) to quantitative mineralogical data from 124 Paleogene and Neogene bentonitic clays from the northern Western Desert of Egypt in order to establish an objective procedure for grouping the samples at three distinctly recognizable, but partially overlapping, levels of classification. These levels were province or geographic region, geologic age, and quarry. Quantitative mineralogical data were obtained by means of X-ray diffraction procedures employing least-squares fitting of simulated and standard mineral patterns with those from the laboratory. All data were transformed by a log-ratio procedure prior to the DFA. Fe-rich smectite (Feoct-1.4 a.p.f.u.), coarsely crystalline kaolinite, Fe-poor I-S (random with 60% S layers), quartz, and illite were the most important discriminator minerals. S-moderate I-S (random with 70% S), S-rich I-S (random with 80% S), two varieties of finely crystalline kaolinite, feldspar, and amorphous matter were also present. Calcite and gypsum were present in some samples. The median wt.% values for Fe-rich smectite, coarsely crystalline kaolinite, Fe-poor I-S, quartz, and illite in all samples were 16.6, 16.0, 15.2, 4.2, and 3.7, respectively. Abundances of quartz and feldspar have a good positive correlation, and finely crystalline kaolinite and Fe-rich smectite are negatively correlated. Other specific mineral associations are difficult to interpret visually because of the numbers of classes and variables employed in the investigation; however, DFA was successful in identifying statistically significant differences amongst the groups.
At the province level, the back-classification of the samples was successful 92% of the time at the highest probability level, or 100% if the first plus second probability results were utilized. For samples of the same age, 80% of the first-choice assignments were correct and >90% were correct when the second choice was included. At the quarry level, the predictability rate ranged from 76 to >90%. Using both probability results, only seven of the samples were misclassified. In a blind test of quarry samples, the DFA assignment was 80% correct. These tests confirm the objective reliability of class assignments based on DFA. Results based on this data set can be used to classify new samples in future geologic interpretations and economic exploitation of the deposits in the region.
The Dispersive Effect of Sodium Hexametaphosphate on Kaolinite in Saline Water
- Mark Ma
-
- Published online by Cambridge University Press:
- 01 January 2024, pp. 405-410
-
- Article
- Export citation
-
Freshwater has become increasingly scarce in many countries. To reduce the consumption of freshwater, the use of saline water resources in industry could provide an opportunity to meet the challenge of water-supply sustainability. However, the presence of electrolytes in saline water causes the coagulation of kaolinite, the colloid stability of which plays a key role in the processing of a number of minerals. Therefore, the dispersion of kaolinite in saline water was studied here. Electrophoretic mobility and colloid stability studies were conducted on a sodium hexametaphosphate-kaolinite system in the presence of NaCl, KCl, CaCl2, and MgCl2, the major electrolytes in saline water resources. The effect of each electrolyte on kaolinite dispersion was studied. Based on the studies of individual electrolytes, a method was developed to disperse kaolinite in 1:1 diluted synthetic seawater with distilled water, which may potentially reduce the consumption of freshwater by 50% when applied in industry.
Stereochemistry and Molecular Recognition on the Surface of a Smectite Clay Mineral
- Akihiko Yamagishi, Hisako Sato
-
- Published online by Cambridge University Press:
- 01 January 2024, pp. 411-419
-
- Article
- Export citation
-
Attempts at optical resolution and asymmetric syntheses using smectite clay minerals are described. Use of the method was prompted by the discovery that the saturated adsorption of a tris(chelated) metal complex, [Ru(1,10-phenanthroline)3]2+, by Na-montmorillonite depended heavily on the stereochemical properties. The pure enantiomer was adsorbed by cation exchange at negative surface sites of the clay mineral, while the racemic mixture was adsorbed to two times excess of the cation exchange capacity. The chelate takes a uniform orientation on a clay mineral surface due to the matching between the molecular symmetry and the two-dimensional network of a phyllosilicate layer. On a clay mineral surface covered with the enantiomeric chelates, a vacant space capable of chiral discrimination was generated. Based on this, an ion-exchange adduct of smectite and the chiral chelate was used as an adsorbent for separating racemic mixtures or selectively producing either one of the optical isomers.
Organic Geochemical Composition of the Georgia Kaolins: Insights into Formation and Diagenetic Conditions
- Michael C. Cheshire, David L. Bish, Simon C. Brassell
-
- Published online by Cambridge University Press:
- 01 January 2024, pp. 420-439
-
- Article
- Export citation
-
Most previous studies of the kaolin deposits in the southeastern United States have focused on their mineralogy and petrology to understand better the depositional and diagenetic environments of the kaolins. Many studies suggest, however, that much of the information held within the minerals was changed during extensive post-depositional groundwater and microbial alteration. Organic δ13C and biomarker analyses were used, therefore, to provide further information on the nature of the original sediments, the depositional environment(s), and the amount of diagenetic alteration that has occurred in Georgia kaolin deposits.
Two different types of kaolin can be discerned, based on their total organic carbon contents: organic-lean kaolin and lignitic kaolin. The bulk organic δ13C in the Georgia kaolins ranges from ~−26 to −19% (VPDB, Vienna Pee Dee Belemnite standard), with a noticeable enrichment in 13C with decrease in organic carbon concentration. The lean kaolins are by far the more dominant types, with an organic-matter composition primarily of C16–C22n-alkanes, C16 and C18 fatty acids, and unresolved complex mixtures. Lignitic kaolin has a distinctly different organic matter (OM) composition. The lignitic material is primarily C15–C33n-alkanes with a greater abundance of C23–C31n-alkanes and lesser amounts of resinous and microbial constituents along with the oxidized forms of the saturated lipid fractions.
Biomarker data suggest that the lignitic material is primarily terrestrially derived from conifers with minor input from microbial lipids. The OM in both types of kaolin shows strong signs of microbial decomposition that yield the organically lean kaolins. The oxidation of the detrital organic matter would subsequently yield organic acids that would have exerted significant influence on the mineralogy and metal mobility.