Hostname: page-component-594f858ff7-r29tb Total loading time: 0 Render date: 2023-06-05T14:30:19.749Z Has data issue: false Feature Flags: { "corePageComponentGetUserInfoFromSharedSession": false, "coreDisableEcommerce": false, "corePageComponentUseShareaholicInsteadOfAddThis": true, "coreDisableSocialShare": false, "useRatesEcommerce": true } hasContentIssue false

Enhanced sedimentation in settling tanks with inclined walls

Published online by Cambridge University Press:  19 April 2006

Andreas Acrivos
Department of Chemical Engineering, Stanford University, California 94305
Eric Herbolzheimer
Department of Chemical Engineering, Stanford University, California 94305


Using the principles of continuum mechanics, a theory is developed for describing quantitatively the sedimentation of small particles in vessels having walls that are inclined to the vertical. The theory assumes that the flow is laminar and that the particle Reynolds number is small, but c0, the concentration in the suspension, and the vessel geometry are left arbitrary. The settling rate S is shown to depend upon two dimensionless groups, in addition to the vessel geometry: a sedimentation Reynolds number R, typically O(1)-O(10); and Λ, the ratio of a sedimentation Grashof number to R, which is typically very large. By means of an asymptotic analysis it is then concluded that, as Λ → ∞ and for a given geometry, S can be predicted from the well-known Ponder-Nakamura-Kuroda formula which was obtained using only kinematic arguments. The present theory also gives an expression for the thickness of the clear-fluid slit that forms underneath the downward-facing segment of the vessel walls, as well as for the velocity profile both in this slit and in the adjoining suspension.

The sedimentation rate and thickness of the clear-fluid slit were also measured in a vessel consisting of two parallel plates under the following set of conditions: c0 ≤ 0·1, RO(1), O(10)5 ≤ Λ ≤ O(107) and 0° ≤ α ≤ 50°, where α is the angle of inclination. Excellent agreement was obtained with the theoretical predictions. This suggests that the deviations from the Ponder-Nakamura-Kuroda formula reported in the literature are probably due to a flow instability which causes the particles to resuspend and thereby reduces the efficiency of the process.

Research Article
© 1979 Cambridge University Press

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)


Barnea, E. & Mizrahi, J. 1973 A generalized approach to the fluid dynamics of particulate systems. Part 1. General correlation for fluidization and sedimentation in solid multiparticle systems. Chem. Engng J. 5, 171189.Google Scholar
Batchelor, G. K. 1956 On steady laminar flow with closed streamlines at large Reynolds number. J. Fluid Mech. 1, 177190.Google Scholar
Boycott, A. E. 1920 Sedimentation of blood corpuscles. Nature, 104, 532.Google Scholar
Graham, W. & Lama, R. 1963 Sedimentation in inclined vessels. Can. J. Chem. Eng. 41, 3132.Google Scholar
Hill, W. D. 1974 Boundary-enhanced sedimentation due to settling convection. Ph.D. thesis, Carnegie-Mellon University, Pittsburgh, Pa.
Hill, W. D., Rothfus, R. R. & Li, K. 1977 Boundary-enhanced sedimentation due to settling convection. Int. J. Multiphase Flow 3, 561583.Google Scholar
Kinosita, K. 1949 Sedimentation in tilted vessels. J. Colloid Interface Sci. 4, 525536.Google Scholar
Kynch, G. J. 1952 A theory of sedimentation. Trans. Faraday Soc. 48, 166176.Google Scholar
Nakamura, H. & Kuroda, K. 1937 La cause de l'accélération de la vitesse de sédimentation des suspensions dans les récipients inclinés. Keijo J. Med. 8, 256296.Google Scholar
Oliver, D. R. & Jenson, V. G. 1964 The inclined settling of dispersed suspensions of spherical particles in square-section tubes. Can. J. Chem. Engng 42, 191195.Google Scholar
Pan, F. & Acrivos, A. 1967 Steady flows in rectangular cavities. J. Fluid Mech. 28, 643655.Google Scholar
Pearce, K. W. 1962 Settling in the presence of downward facing surfaces. Proc. 3rd Congr. Eur. Fed. Chem. Engng, Lond. pp. 3039.Google Scholar
Ponder, E. 1925 On sedimentation and rouleaux formation. Quart J. Expt. Physiol. 15, 235252.Google Scholar
Vohra, D. K. & Ghosh, B. 1971 Studies of sedimentation in inclined tubes. Ind. Chem. Engng 13, 3240.Google Scholar
Zahavi, E. & Rubin, E. 1975 Settling of solid suspensions under and between inclined surfaces. Ind. and Engng Chem., Proc. Design and Dev. 14, 3441.Google Scholar