Hostname: page-component-8448b6f56d-m8qmq Total loading time: 0 Render date: 2024-04-24T11:54:50.709Z Has data issue: false hasContentIssue false

An experimental investigation of turbulent shear flow cavitation

Published online by Cambridge University Press:  26 April 2006

T. J. O'Hern
Affiliation:
Fluid and Thermal Sciences Department, Sandia National Laboratories, Albuquerque, NM 87185, USA

Abstract

Cavitation inception in a turbulent shear layer was studied at Reynolds numbers up to 2 × 106. Flash photography, high-speed motion pictures and holography were used to study the relation of cavitation inception to the shear-layer turbulent structure. Both spanwise and streamwise vortices were clearly visualized by the cavitation. Cavitation inception consistently occurred in the streamwise vortices and more fully developed cavitation was visible in both structures, with the streamwise cavities typically confined to the braid regions between adjacent spanwise vortices. The strength of the streamwise vortices was estimated using a Rankine vortex model, which showed that their strength was always less than 10% of that of the spanwise vortices. Measurements of fluctuating pressures were made by holographically monitoring the size of air bubbles injected into the non-cavitating shear flow. The measured pressure fluctuations had positive and negative peaks as high as 3 times the free-stream dynamic pressure, sufficient to explain cavitation inception at high values of the inception index. The occurrence of inception in the streamwise vortices of the shear layer, combined with previous reports of velocity dependence of the streamwise vortex strength, may explain the commonly observed Reynolds-number scaling of the cavitation inception index in shear flows.

Type
Research Article
Copyright
© 1990 Cambridge University Press

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

Arndt, R. E. A. 1978 Investigation of the effects of dissolved gas and free nuclei on cavitation and noise in the wake of a sharp-edged disk. Joint IAHR/ASME/ASCE Symp. on Fluid Machinery, Fort Collins, Colorado.
Arndt, R. E. A. & George, W. K. 1979 Pressure fields and cavitation in turbulent shear flows. 12th Symp. on Naval Hydrodynamics, Washington, DC. National Academy Press.
Ashurst, W. T. & Meiburg, E. 1988 Three-dimensional shear layers via vortex dynamics. J. Fluid Mech. 189, 87116.Google Scholar
Batt, R. G. 1977 Turbulent mixing of passive and chemically reactive species in a low-speed shear layer. J. Fluid Mech. 82, 5395.Google Scholar
Bernal, L. P. 1981 The coherent structure of turbulent mixing layers, I. Similarity of the primary vortex structure, II. Secondary streamwise vortex Structure. Ph.D. thesis. Graduate Aeronautical Laboratories, California Institute of Technology.
Bernal, L. P. & Roshko, A. 1986 Streamwise vortex structure in plane mixing layers. J. Fluid Mech. 170, 499525.Google Scholar
Brown, G. L. & Roshko, A. 1974 On density effects and large structure in turbulent mixing layers. J. Fluid Mech. 64, 775816.Google Scholar
Clark, J. A. & Kit, L. 1980 Shear layer transition and the sharp-edged orifice. Trans. ASME J: J. Fluids Engng 102, 219225.Google Scholar
Dimotakis, P. E. & Brown, G. L. 1976 The mixing layer at high Reynolds number: large-structure dynamics and entrainment. J. Fluid Mech. 78, 535560.Google Scholar
Fiedler, H. E. & Mensing, P. 1985 The plane turbulent shear layer with periodic excitation. J. Fluid Mech. 150, 281309.Google Scholar
Franc, J. P. & Michel, J. M. 1983 Two- and three-dimensional rotational structures in the cavitating turbulent wake of a wedge. Presented at the Fourth Symp. on Turbulent Shear Flows, Karlsruhe, Germany.
Gates, E. M. 1977 The influence of freestream turbulence, freestream nuclei populations and a drag-reducing polymer on cavitation inception on two axisymmetric bodies. Ph.D. thesis, California Institute of Technology, Rep. 183-2.
Goldstein, S. (ed.) 1965 Modern Developments in Fluid Dynamics, Volume II, p. 599. Dover.
Hernan, M. A. & Jimenez, J. 1982 Computer analysis of a high-speed film of the plane turbulent mixing layer. J. Fluid Mech. 119, 323345.Google Scholar
Ho, C. M. & Huerre, P. 1984 Perturbed free shear layers. Ann. Rev. Fluid Mech. 16, 365424.Google Scholar
Jimenez, J. 1983 A spanwise structure in the plane shear layer. J. Fluid Mech. 132, 319336.Google Scholar
Jimenez, J., Cogollos, M. & Bernal, L. 1985 A perspective view of the plane mixing layer. J. Fluid Mech. 152, 125143.Google Scholar
Katz, J. 1984 Cavitation phenomena within regions of flow separation. J. Fluid Mech. 140, 397436.Google Scholar
Katz, J. & O'Hern, T. J. 1986 Cavitation in large scale shear flows. Trans. ASME J: J. Fluids Engng 108, 373376.Google Scholar
Kermeen, R. W. & Parkin, B. R. 1957 Incipient cavitation and wake flow behind sharp-edged disks. California Institute of Technology, Hydrodynamics Lab Rep. 85-4.
Lasheras, J. C., Cho, J. S. & Maxworthy, T. 1986 On the origin and evolution of streamwise vortical structures in a plane, free shear layer. J. Fluid Mech. 172, 231258.Google Scholar
Moore, D. W. & Saffman, P. G. 1975 The density of organized vortices in a turbulent mixing layer. J. Fluid Mech. 69, 465473.Google Scholar
O'Hern, T. J. 1987 Cavitation inception scale effects I. Nuclei distributions in natural waters II. Cavitation inception in a turbulent shear flow. Ph.D. thesis, California Institute of Technology, Rep. Eng. 183.15.
Ooi, K. K. 1981 Scale effects on cavitation inception in submerged jets. Ph.D. thesis, California Institute of Technology, Rep. 183-6.
Ooi, K. K. 1985 Scale effects of cavitation inception in submerged water jets: a new look. J. Fluid Mech. 151, 367390.Google Scholar
Ooi, K. K. & Acosta, A. J. 1983 The utilization of specially tailored air bubbles as static pressure sensors in a jet. ASME Paper 83-FE-34.
Ruderich, R. & Fernholz, H. H. 1986 An experimental investigation of a turbulent shear flow with separation, reverse flow, and reattachment. J. Fluid Mech. 163, 283322.Google Scholar
Van der Muelen, J. H. J. 1980 Boundary layer and cavitation studies of NACA 16–012 and NACA 4412 hydrofoils. 13th Symp. on Naval Hydrodynamics, Sasakawa Hall, Tokyo. Tokyo: Shipbuilding Research Association of Japan.
Winant, C. D. & Browand, F. K. 1974 Vortex-pairing: the mechanism of turbulent mixing layer growth at moderate Reynolds number. J. Fluid Mech. 63, 237255.Google Scholar
Young, J. O. & Holl, J. W. 1966 Effects of cavitation on periodic wakes behind symmetric wedges. Trans. ASME D: J. Basic Engng 88D, 163176.Google Scholar