Hostname: page-component-7dd5485656-bvgqh Total loading time: 0 Render date: 2025-10-30T00:09:17.580Z Has data issue: false hasContentIssue false
  • English
  • Français

Modifying turbulent structure with drag-reducing polymer additives in turbulent channel flows

Published online by Cambridge University Press:  26 April 2006

T. Wei  and
W. W. Willmarth
T. Wei
Affiliation:
Department of Mechanical and Aerospace Engineering, Rutgers University, Piscataway, NJ 08855-0909, USA
W. W. Willmarth
Affiliation:
Department of Aerospace Engineering, University of Michigan, Ann Arbor, MI 48109-2140, USA
Get access Rights & Permissions [Opens in a new window]

Abstract

New power spectra computed from LDA measurements of the fluctuating u- and v-velocity signals in a turbulent channel flow with and without drag-reducing polymer (polyethylene oxide) injection are presented. LDA data rates were sufficiently high to reconstruct the simultaneous time-dependent u- and v-velocity signals along with the time-dependent Reynolds stress signal. Time-averaged statistics of the turbulent flow are presented in conjunction with the power spectral measurements which show a dramatic reduction in both the v-velocity fluctuations and Reynolds stress fluctuations throughout the channel over all frequencies. There is also a redistribution of energy in the u-velocity fluctuations from high frequencies to low frequencies throughout the channel. Different injection conditions were examined: different polymer concentrations were injected at different flow rates such that the total amount of polymer in the channel remained constant. For certain polymer concentrations, ‘large’ negative Reynolds stress, -〈uv〉/uτ2 ≈ − 0.2, was measured in the near-wall region. In addition, there is a marked difference in the u-velocity spectra and the Reynolds stress spectra close to the wall for the different injection conditions.

Information

Type
Research Article
Information
Journal of Fluid Mechanics , Volume 245 , December 1992 , pp. 619 - 641
Copyright
© 1992 Cambridge University Press

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable

References

Achia, B. U. & Thompson D. W. 1977 Structure of the turbulent boundary in drag-reducing pipe flow. J. Fluid Mech. 81, 439.Google Scholar
Berman N. S. 1977 Flow time scales and drag reduction. Phys. Fluids 20, S168.Google Scholar
Berman N. S. 1986 Velocity fluctuations in non-homogeneous drag reduction. Chem. Engng Commun. 42, 37.Google Scholar
Berman N. S. 1990 Large eddies and polymer strings. In Structure of Turbulence and Drag Reduction (ed. A. Gyr), p. 275. Springer.
Berner, C. & Scrivener, O. 1979 Drag reduction and structure of turbulence in dilute polymer solutions. In Viscous Flow Drag Reduction (ed. G. R. Hough). Progress in Astronautics and Aeronautics, vol. 72, p. 290. AIAA.
Bewersdorff H. W. 1984 Heterogene Widerstandsverminderung bei turbulenten Rohrströ-mungen. Rheol. Acta 23, 522.Google Scholar
Bradshaw P. 1965 The effect of wind tunnel screens on nominally two-dimensional boundary layers. J. Fluid Mech. 22, 679.Google Scholar
Coles D. 1953 Measurements in the boundary layer of a smooth flat plate in supersonic flow; Part 1. The problem of the turbulent boundary layer. JPL/Cal Tech Rep. 20–69.Google Scholar
Donohue G. L., Tiederman, W. G. & Reischman M. M. 1972 Flow visualization of the near-wall region in a drag-reducing channel flow. J. Fluid Mech. 56, 559.Google Scholar
Durst F., Keck, T. & Kleine. R. 1985 Turbulence quantities and Reynolds stress in pipe flow of polymer solutions. Proc. 1st Intl Conf. on Laser Anemometry - Advances and Applications, p. 31. BHRA.Google Scholar
Gordon R. J. 1970 Mechanism for turbulent drag reduction in dilute polymer solutions. Nature 227, 599.Google Scholar
Hinch E. J. 1977 Mechanical models of dilute polymer solutions in strong flows. Phys. Fluids 20, S22.Google Scholar
Kline S. J., Reynolds, W. C., Schraub, F. A. & Runstadtler, P. W. 1967 The structure of turbulent boundary layers. J. Fluid Mech. 30, 741.Google Scholar
Luchik, T. S. & Tiederman. W. G. 1988 Turbulent structure in low-concentration drag-reducing channel flows. J. Fluid Mech. 190, 241.Google Scholar
Lumley J. L. 1969 Drag reduction by additives. Ann. Rev. Fluid Mech. 1, 367.Google Scholar
McComb, W. D. & Rabie L. H. 1982 Local drag reduction due to injection of polymer solutions into turbulent flow in a pipe. AICHE J. 28, 547.Google Scholar
McCormick C. L., Hester, R. D., Morgan, S. E. & Safieddine, A. M. 1990a Water-soluble copolymers. 30. Effects of molecular structure on drag reduction efficiency. Macromol. 23, 2124.Google Scholar
McCormick C. L., Hester R. D., Morgan, S. E. & Safieddine A. M. 1990b Water-soluble copolymers. 31. Effects of molecular parameters, solvation, and polymer associations on drag reduction performance, Macromol. 23, 2132.Google Scholar
Perry, A. E. & Abell C. J. 1975 Scaling laws for pipe flow turbulence. J. Fluid Mech. 67, 257.Google Scholar
Rabin, Y. & Zielinska B. J. A. 1989 Scale-dependent enhancement and damping of vorticity disturbances by polymers in elongational flow. Phys. Rev. Lett. 63, 512.Google Scholar
Reischman, M. M. & Tiederman W. G. 1975 Laser-Doppler anemometer measurements in drag-reducing channel flows. J. Fluid Mech. 70, 369.Google Scholar
Rudd M. J. 1972 Velocity measurements made with a laser dopplermeter on the turbulent pipe flow of a dilute polymer solution. J. Fluid Mech. 51, 673.Google Scholar
Stenberg L. G., Lagerstedt T., Sehlén, O. & Lindgren E. R. 1977 Mechanical mixing of polymer additive in turbulent drag reduction. Phys. Fluids 20, 858.Google Scholar
Tiederman W. G., Luchik, T. S. & Bogard D. G. 1985 Wall-layer structure and drag reduction. J. Fluid Mech. 156, 419.Google Scholar
Usui H. 1990 Drag reduction caused by the injection of a polymer solution into a pipe flow. In Structure of Turbulence and Drag Reduction (ed. A. Gyr). Springer.
Virk P. S., Merrill E. W., Mickley H. S., Smith, K. A. & Mollo-Christensen E. L. 1967 The Toms phenomenon: turbulent pipe flow of dilute polymer solutions. J. Fluid Mech. 30, 305.Google Scholar
Wei T. 1987 Reynolds number effects on the small scale structure of a turbulent channel flow, Ph.D. thesis, The University of Michigan.
Wei, T. & Willmarth W. W. 1989 Reynolds number effects on the structure of a turbulent channel flow. J. Fluid Mech. 204, 57.Google Scholar
Willmarth W. W., Wei, T. & Lee C. O. 1987 Laser anemometer measurements of Reynolds stress in a turbulent channel flow with drag reducing polymer additives. Phys. Fluids 30, 933.Google Scholar
Zakin, J. L. & Hunston D. L. 1980 Effect of polymer molecular variables on drag reduction J. Macromol. Sci. Phys. B 18, 795.Google Scholar