Hostname: page-component-848d4c4894-m9kch Total loading time: 0 Render date: 2024-05-15T20:01:48.419Z Has data issue: false hasContentIssue false

On the applicability of various scaling laws to the turbulent wall jet

Published online by Cambridge University Press:  26 April 2006

I. Wygnanski
Affiliation:
Department of Aerospace and Mechanical Engineering, University of Arizona, Tucson, AZ 85721, USA
Y. Katz
Affiliation:
Department of Aerospace and Mechanical Engineering, University of Arizona, Tucson, AZ 85721, USA
E. Horev
Affiliation:
Department of Aerospace and Mechanical Engineering, University of Arizona, Tucson, AZ 85721, USA

Abstract

The spatial distribution of the mean velocity in a two-dimensional turbulent wall jet was measured for a variety of nozzle Reynolds numbers. It was determined that the bulk of the flow is self-similar and it depends on the momentum flux at the nozzle and on the viscosity and density of the fluid. The width of the nozzle which was commonly used to reduce these data has no part in the similarity considerations as has already been suggested by Narasimha et al. (1973). This type of self-similarity can be easily applied to determine the skin friction, which can otherwise only be determined with considerable difficulty. It was also shown that the ‘law of the wall’ applies only to the viscous sublayer. The Reynolds stress in the inviscid, inner portion of the flow is not constant thus the assumption of a ‘constant stress layer’ is not applicable. The applicability and universality of the ‘outer scaling law’ (i.e. Coles’ law of the wake) has been verified throughout the inviscid inner portion of the wall jet. The logarithmic velocity distribution cannot be derived by making the usual assumptions based on the constancy of the Reynolds stresses or on the thinness of the logarithmic region relative to the thickness of the inner layer.

Type
Research Article
Copyright
© 1992 Cambridge University Press

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

Bradshaw, P. & Gee, M. Y. 1960 Turbulent wall jets with and without an external stream. Aero. Res. Coun. R & M 3252.Google Scholar
Coles, D. 1956 The law of the wake in a turbulent boundary layer. J. Fluid Mech. 1, 191.Google Scholar
Coles, D. E. & Hirst, E. A. 1968 AFOSR-IFP Stanford Conf. on Computation of Turbulent Boundary-Layers, Thermosciences Division, Stanford University.
Forthmann, E. 1934 Uber turbulente Strahlausbreitung. Ing. Arch. 5, 42.Google Scholar
Guitton, D. E. & Newman, B. G. 1977 Self-preserving turbulent wall jets over convex surfaces. J. Fluid Mech. 81, 155.Google Scholar
Irwin, H. P. A. H. 1973 Measurements in a self-preserving plane wall jet in a positive pressure gradient. J. Fluid Mech. 61, 33.Google Scholar
Launder, B. E. & Rodi, W. 1981 The turbulent wall jets. Prog. Aerospace Sci. 19, 81.Google Scholar
Launder, B. E. & Rodi, W. 1983 The turbulent wall jet — measurements and modeling. Ann. Rev. Fluid Mech. 15, 429.Google Scholar
Myers, G. E., Scahuer, J. J. & Eustis, R. H. 1963 Plane turbulent wall jet flow development and friction factor. Trans. ASME J: J. Basic Engng 85, 47.Google Scholar
Narasimha, R., Narayan, K. Y. & Parthasarathy, S. P. 1973 Parametric analysis of turbulent wall jets in still air. Aeronaut. J. 77, 335.Google Scholar
Newman, B. G. 1961 The deflexion of plane jets by adjacent boundaries — Coanda effect. In Boundary Layer and Flow Control. Pergamon.
Ozarapoglu, V. 1973 Measurements in incompressible turbulent flows. D.Sc. thesis, Laval University, Quebec City.
Patel, R. P. 1962 Self preserving two dimensional turbulent jets and wall jets in a moving stream. M.Sc. thesis, McGill University, Montreal.
Patel, V. C. 1965 Calibration of the Preston tube and limitations on its use in pressure gradients. J. Fluid Mech. 23, 185.Google Scholar
Schwarz, W. H. & Cosart, W. P. 1961 The two-dimensional turbulent wall-jet. J. Fluid Mech. 10, 481.Google Scholar
Sigalla, A. 1958 Measurements of a skin friction in a plane turbulent wall jet. J. R. Aero. Soc. 62, 873.Google Scholar
Sreenivasan, K. R. & Narasimha, R. 1982 Equilibrium parameters for two-dimensional turbulent wakes. Trans. ASME I: J. Fluids Engng 104, 167.Google Scholar
Tailland, A. & Mathieu, J. 1967 Jet parietal. J. Méc. 6, 1.Google Scholar
Wills, J. A. B. 1962 The correction of hot-wire readings for proximity to a solid boundary. J. Fluid Mech. 12, 388.Google Scholar