Hostname: page-component-7dd5485656-pnlb5 Total loading time: 0.001 Render date: 2025-10-31T03:17:59.509Z Has data issue: false hasContentIssue false
  • English
  • Français

Three-dimensional features in low-Reynolds-number confined corner flows

Published online by Cambridge University Press:  13 December 2010

LAURA GUGLIELMINI ,
R. RUSCONI ,
S. LECUYER  and
H. A. STONE
LAURA GUGLIELMINI*
Affiliation:
Department of Mechanical and Aerospace Engineering, Princeton University, Princeton, NJ 08544, USA
R. RUSCONI
Affiliation:
School of Engineering and Applied Sciences, Harvard University, Cambridge, MA 02138, USA
S. LECUYER
Affiliation:
School of Engineering and Applied Sciences, Harvard University, Cambridge, MA 02138, USA
H. A. STONE
Affiliation:
Department of Mechanical and Aerospace Engineering, Princeton University, Princeton, NJ 08544, USA
*
†Email address for correspondence: lauragug@stanford.edu, hastone@princeton.edu
Get access Rights & Permissions [Opens in a new window]

Abstract

In recent microfluidic experiments with solutions of bacteria we observed the formation of biofilms in the form of thread-like structures, called ‘streamers’, which float in the middle plane of the channel and are connected to the side walls at the inner corners. Motivated by this observation, we discuss here the pressure-driven low-Reynolds-number flow around a corner bounded by the walls of a channel with rectangular cross-section. We numerically solve the flow field in a channel of constant cross-section, which exhibits 90° sharp corners, or turns with constant curvature, or portions with slowly changing curvature along the flow direction, for finite, but small, values of the Reynolds numbers and including the limit of vanishingly small Reynolds numbers. In addition, we develop a matched asymptotic expansion solution for the flow around two boundaries intersecting at an angle α and spanning the small gap h between two horizontal plates. We illustrate the basic features of the flow in these channel geometries by describing the three-dimensional velocity field and the distribution of streamwise vorticity and helicity, and comparing the numerical solutions with predictions based on the asymptotic approach. We demonstrate that near a corner or a change in the curvature of the side wall the flow is three-dimensional and pairs of counter-rotating vortical structures are present, as identified by Balsa (J. Fluid Mech., vol. 372, 1998, p. 25). Finally, we discuss how this secondary flow depends on the significant geometric parameters, the aspect ratio of the channel cross-section, the radius of curvature of the turn and, more generally, the variation of the curvature of the channel side boundary. We believe that these three-dimensional secondary flow structures are relevant to transport problems where accumulation of material at the boundary is possible.

JFM classification

Low-Reynolds-number flows: Hele-Shaw flows Micro-/Nano-fluid dynamics: Microfluidics Low-Reynolds-number flows: Stokesian dynamics

Information

Type
Papers
Information
Journal of Fluid Mechanics , Volume 668 , 10 February 2011 , pp. 33 - 57
Copyright
Copyright © Cambridge University Press 2010

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable

References

REFERENCES

Balsa, T. F. 1998 Secondary flow in a Hele-Shaw cell. J. Fluid Mech. 372, 25–44.CrossRefGoogle Scholar
Davis, A. M. J. & O'Neill, M. E. 1977 Separation in a slow linear shear flow past a cylinder and a plane. J. Fluid Mech. 81, 551–564.CrossRefGoogle Scholar
Gomilko, A. M., Malyuga, V. S. & Meleshko, V. V. 2003 On steady Stokes flow in a trihedral rectangular corner. J. Fluid Mech. 476, 159–177.CrossRefGoogle Scholar
Hills, C. P. & Moffatt, H. K. 2000 Rotary honing: a variant of the Taylor paintscraper problem. J. Fluid Mech. 418, 119–135.CrossRefGoogle Scholar
Jeffrey, D. J. & Sherwood, J. D. 1980 Streamline patterns and eddies in low-Reynolds-number flow. J. Fluid Mech. 96, 315–334.CrossRefGoogle Scholar
Lauga, E., Stroock, A. D. & Stone, H. A. 2004 Three-dimensional flows in slowly varying planar geometries. Phys. Fluids 16, 3051–3062.CrossRefGoogle Scholar
Lee, J. S. & Fung, Y. C. 1969 Stokes flow around a circular cylindrical post confined between two parallel plates. J. Fluid Mech. 37, 657–670.CrossRefGoogle Scholar
Liu, R. H., Stremler, M. A., Sharp, K. V., Olsen, M. G., Santiago, J. G., Adrian, R. J., Aref, H. & Beebe, D. J. 2000 Passive mixing in a three-dimensional serpentine microchannel. J. Microelectromech. Syst. 9, 190–197.CrossRefGoogle Scholar
Moffatt, H. K. 1964 Viscous and resistive eddies near a sharp corner. J. Fluid Mech. 18, 1–18.CrossRefGoogle Scholar
Riegels, F. 1938 Zur kritik des Hele-Shaw-versuchs. ZAMM 18, 95–106.CrossRefGoogle Scholar
Rusconi, R., Lecuyer, S., Guglielmini, L. & Stone, H. A. 2010 Laminar flow around corners triggers the formation of biofilm streamers. J. R. Soc. Interf. 7, 1293–1299.CrossRefGoogle ScholarPubMed
Shankar, N. P. 2000 On Stokes flow in a semi-infinite wedge. J. Fluid Mech. 422, 69–90.CrossRefGoogle Scholar
Shankar, P. N. 2007 Slow Viscous Flow. Imperial College Press.CrossRefGoogle Scholar
Squires, T. M. & Quake, S. R. 2005 Microfluidics: fluid physics on the nanoliter scale. Rev. Mod. Phys. 77, 977–1026.CrossRefGoogle Scholar
Stone, H. A., Stroock, A. D. & Ajdari, A. 2004 Engineering flows in small devices. Annu. Rev. Fluid Mech. 36, 381–411.CrossRefGoogle Scholar
Thompson, B. W. 1968 Secondary flow in a Hele-Shaw cell. J. Fluid Mech. 31, 379–395.CrossRefGoogle Scholar
Yi, M. & Bau, H. H. 2003 The kinematics of bend-induced mixing in micro-conduits. Intl J. Heat Fluid 24, 645–656.CrossRefGoogle Scholar