Skip to main content
×
Home
    • Aa
    • Aa

Indentation fracture of low-dielectric constant films: Part I. Experiments and observations

  • Dylan J. Morris (a1) and Robert F. Cook (a1)
Abstract

Advanced microelectronic interconnection structures will need dielectrics of low permittivity to reduce capacitive delays and crosstalk, but this reduction in permittivity typically necessitates an increase in the porosity of the material, which is frequently accompanied by reduced mechanical reliability. Failure by brittle fracture remains a typical manufacturing and reliability hurdle for this class of materials. Part I of this two-part work explores the instrumented indentation and indentation fracture responses of a variety of organosilicate low-dielectric constant (low-κ) films. Three different chemical varieties of low-κ material were tested. The influence of film thickness on the fracture response is also explored systematically. Correlations are made between instrumented indentation responses and differing modes of fracture. It is demonstrated that the elastic response of the composite film + substrate systems can be simply tied to the fraction of the total indentation strain energy in the film. These results are then used in the companion paper, Part II [D.J. Morris and R.F. Cook, J. Mater. Res.23, 2443 (2008)], to derive and use a fracture mechanics model to measure fracture properties of low-κ films.

Copyright
Corresponding author
a)Address all correspondence to this author. e-mail: dylan.morris@nist.gov
References
Hide All
2 G.R. Anstis , P. Chantikul , B.R. Lawn D.B. Marshall : A critical evaluation of indentation techniques for measuring fracture toughness. I. Direct crack measurements. J. Am. Ceram. Soc. 64, 5331981

4 A. Arora , D.B. Marshall , B.R. Lawn M.V. Swain : Indentation deformation/fracture of normal and anomalous glasses. J. Non-Cryst. Solids 31, 4151979

5 D.J. Morris R.F. Cook : Indentation fracture of low-dielectric constant films: Part II. Indentation fracture mechanics model. J. Mater. Res. 23, 24432008

11 K. Ikezawa T. Maruyama : Sharp tip geometry and its effect on hardness in nanoindentation experiments. J. Appl. Phys. 91, 96892002

13 K. Kese D.J. Rowcliffe : Nanoindentation method for measuring residual stress in brittle materials. J. Am. Ceram. Soc. 86, 8112003

14 D.J. Morris R.F. Cook : In situ cube-corner indentation of soda-lime glass and fused silica. J. Am. Ceram. Soc. 87, 14942004

15 S. Lathabai , J. Rodel , T. Dabbs B.R. Lawn : Fracture mechanics model for subthreshold indentation flaws. I. Equilibrium fracture. J. Mater. Sci. 26, 21571991

16 R. Dal Maschio : Application of the Hagan model for crack nucleation to radial cracks in glass. J. Mater. Sci. Lett. 4, 9481985

17 B.R. Lawn A.G. Evans : A model for crack initiation in elastic/plastic indentation fields. J. Mater. Sci. 12, 21951977

18 R.F. Cook L.M. Braun : Trapped cracks at indentations. II. Fracture mechanics model. J. Mater. Sci. 29, 21921994

19 D.J. Morris R.F. Cook : Radial fracture during indentation by acute probes: I, Description by an indentation wedging model. Int. J. Fract. 136, 2372005

20 S. Kim , Y. Toivola , R.F. Cook , K. Char , S-H. Chu , J-K. Lee , D.Y. Yoon H-W. Rhee : Organosilicate spin-on glasses. I. Effect of chemical modification on mechanical properties. J. Electrochem. Soc. 151, 372004

21 Y. Toivola , K. Suhan , R.F. Cook , K. Char , J-K. Lee , D.Y. Yoon , H-W. Rhee , S.Y. Kim M.Y. Jin : Organosilicate spin-on glasses. II. Effect of physical modification on mechanical properties. J. Electrochem. Soc. 151, 452004

22 Y. Toivola , J. Thurn R.F. Cook : Structural, electrical, and mechanical properties development during curing of low-k hydrogen silsesquioxane films. J. Electrochem. Soc. 149, 92002

23 R.F. Cook G.M. Pharr : Direct observation and analysis of indentation cracking in glasses and ceramics. J. Am. Ceram. Soc. 73, 7871990

24 A.A. Volinsky W.W. Gerberich : Nanoindentaion techniques for assessing mechanical reliability at the nanoscale. Microelectron. Eng. 69, 5192003

25 X. Huang A.A. Pelegri : Nanoindentation measurements on low-k porous silica thin films spin coated on silicon substrates. J. Eng. Mater.-T. ASME 125, 3612003

26 L. Shen K. Zeng : Comparison of mechanical properties of porous and non-porous low-k dielectric films. Microelectron. Eng. 71, 2212004

28 E.H. Yoffe : The elastic compliance of a surface film on a substrate. Philos. Mag. Lett. 77, 691998

29 M.T. Kim : Influence of substrates on the elastic reaction of films for the microindentation tests. Thin Solid Films 283, 121996

34 H. Xu G.M. Pharr : An improved relation for the effective elastic compliance of a film/substrate system during indentation by a flat cylindrical punch. Scr. Mater. 55, 3152006

Recommend this journal

Email your librarian or administrator to recommend adding this journal to your organisation's collection.

Journal of Materials Research
  • ISSN: 0884-2914
  • EISSN: 2044-5326
  • URL: /core/journals/journal-of-materials-research
Please enter your name
Please enter a valid email address
Who would you like to send this to? *
×

Keywords:

Metrics

Full text views

Total number of HTML views: 2
Total number of PDF views: 16 *
Loading metrics...

Abstract views

Total abstract views: 70 *
Loading metrics...

* Views captured on Cambridge Core between September 2016 - 18th October 2017. This data will be updated every 24 hours.