Hostname: page-component-7bb8b95d7b-s9k8s Total loading time: 0 Render date: 2024-09-23T09:39:31.400Z Has data issue: false hasContentIssue false
  • English
  • Français

Square-Cylinder Flow Characteristics Modulated Using Upstream Control Rod

Published online by Cambridge University Press:  08 May 2012

S. C. Yen  and
S. F. Wu
S. C. Yen*
Affiliation:
Department of Mechanical and Mechatronic Engineering, National Taiwan Ocean University, Keelung, Taiwan 20224, R.O.C.
S. F. Wu
Affiliation:
Department of Mechanical and Mechatronic Engineering, National Taiwan Ocean University, Keelung, Taiwan 20224, R.O.C.
*
*Corresponding author (scyen@mail.ntou.edu.tw)
Get access

Abstract

The flow patterns, vortex-shedding frequency and aerodynamic performance of the square-cylinder flow were modulated using an upstream control rod. Additionally, the flow behaviors were examined using various Reynolds numbers, rotation angles, and spacing ratios. The flow patterns were visualized using the smoke-wire scheme. The global velocity fields and streamline patterns were analyzed using the particle image velocimetry (PIV). Additionally, the flow modes were characterized based on the kinematics theory. Moreover, the vortex-shedding frequencies behind upstream control rod and the square cylinder were detected using two hot-wire anemometers. The surface pressure on square cylinder was determined using a linear pressure scanner. Then, the aerodynamic parameters were calculated using the surface-pressure profiles. Three characteristic flow modes — single, attached, and bi-vortex-street — were categorized by varying the Reynolds number and spacing ratio. In the attached mode, the position of upstream control rod determined the flow characteristics. Furthermore, in the attached mode, the mean drag force of the square cylinder is about 57% lower than of single-square cylinder.

Keywords

Upstream control rodSmoke wirePIVVortex shedding
Type
Articles
Information
Journal of Mechanics , Volume 28 , Issue 2 , June 2012 , pp. 279 - 289
Copyright
Copyright © The Society of Theoretical and Applied Mechanics, R.O.C. 2012

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Gad-el-Hak, M., “Introduction to Flow Control,” Eds.: Gad-el-Hak, M., Pollard, A., and Bonnet, J.-P., Flow Control: Fundamentals and Practices, Springer-Verlag, Berlin, pp. 1–153 (1998).CrossRefGoogle Scholar
2. Gad-el-Hak, M., Flow Control – Passive, Active, and Reactive Flow Management, Cambridge University Press, New York, pp. 150–228 (2000).CrossRefGoogle Scholar
3. Okajima, A., “Strouhal Numbers of Rectangular Cylinders,” Journal of Fluid Mechanics, 123, pp. 379–398 (1982).CrossRefGoogle Scholar
4. Zdravkovich, M. M., “Review of Flow Interference between Two Circular Cylinders in Various Arrangements,” ASME Journal of Fluids Engineering, 99, pp. 618–633 (1977).CrossRefGoogle Scholar
5. Yen, S. C., San, K. C. and Chuang, T. H., “Interactions of Tandem Square Cylinders at Low Reynolds Numbers,” Experimental Thermal and Fluid Science, 32, pp. 927–938 (2008).CrossRefGoogle Scholar
6. Lesage, F. and Gartshore, I. S., “A Method of Reducing Drag and Fluctuating Side Force on Bluff Bodies,” Journal of Wind Engineering and Industrial Aerodynamics, 25, pp. 229–245 (1987).CrossRefGoogle Scholar
7. Sakamoto, H., Tan, K. and Haniu, H., “An Optimum Suppression of Fluid Forces by Controlling a Shear Layer Separated from a Square Prism,” Journal of Fluids Engineering, 113, pp. 183–189 (1991).CrossRefGoogle Scholar
8. Strykowski, P. J. and Sreenivasan, K. R., “On the Formation and Suppression of Vortex Shedding at Low Reynolds Numbers,” Journal of Fluid Mechanics, 218, pp. 71–107 (1990).CrossRefGoogle Scholar
9. Zhang, P. F., Wang, J. J., Lu, S. F. and Mi, J., “Aerodynamic Characteristics of a Square Cylinder with a Rod in a Staggered Arrangement,” Experiments in Fluids, 38, pp. 494–502 (2005).CrossRefGoogle Scholar
10. Sarioglu, M., Akansu, Y. E. and Yavuz, T., “Control of Flow Around Square Cylinders at Incidence by Using a Rod,” AIAA Journal, 43, pp. 1419–1426 (2005).CrossRefGoogle Scholar
11. Lesage, F. and Gartshore, I. S., “A Method of Reducing Drag and Fluctuating Side Force on Bluff Bodies,” Journal of Wind Engineering and Industrial Aerodynamics, 25, pp. 229–245 (1987).CrossRefGoogle Scholar
12. West, G. S. and Apelt, C. J., “The Effects of Tunnel Blockage and Aspect Ration on the Mean Flow Past a Circular Cylinder with Reynolds Number Between 104 and 105,” Journal of Fluid Mechanic, 114, pp. 361–377 (1982).CrossRefGoogle Scholar
13. Yen, S. C. and Hsu, C. M., “Flow Patterns and Wake Structure of a Swept-Back Wing,” AIAA Journal, 45, pp. 228–236 (2007).CrossRefGoogle Scholar
14. Mueller, T. J., “Flow Visualization by Direct Injection,” Ed.: Goldstein, R. J., Fluid Mechanics Measurements, 2nd ed., Taylor & Francis, Washington DC, pp. 367–450 (2000).Google Scholar
15. Hinds, W. C., Aerosol Technology, John Wiley, New York, pp. 104–126 (1982).Google Scholar
16. Keane, R. D. and Adrian, R. J., “Theory of Cross-Correlation Analysis of PIV Images,” Applied Scientific Research, 49, pp. 191–215 (1992).CrossRefGoogle Scholar
17. Keane, R. D. and Adrian, R. J., “Optimization of Particle Image Velocimeters Part I: Double Pulsed Systems,” Measurement Science and Technology, 1, pp. 1202–1215 (1990).CrossRefGoogle Scholar
18. Abernethy, R. B., Benedict, R. P. and Dowdell, R. B., “ASME Measurement Uncertainty,” ASME Journal of Fluids Engineering, 107, pp. 161–164 (1985).CrossRefGoogle Scholar
19. Levi, E., “A Universal Strouhal Law,” ASCE Journal of Engineering Mechanics, 109, pp. 718–727 (1983).CrossRefGoogle Scholar
20. Roshko, A., “On the Development of Turbulent Wakes from Vortex Streets,” NACA Report, 1191 (1954).Google Scholar
21. Bearman, P. B., “On Vortex Street Wakes,” Journal of Fluid Mechanics, 28, pp. 625–641 (1967).CrossRefGoogle Scholar
22. Coles, D., “The Uses of Coherent Structures,” Aerospace Sciences Meeting, Reno, Nevada, AIAA Journal, pp. 85–0506 (1985).Google Scholar
23. Perry, A. E. and Fairlie, B. D., “Critical Points in Flow Patterns,” Advances in Geophysics B, 18, pp. 299–315 (1974).CrossRefGoogle Scholar
24. Chong, M. S. and Perry, A. E., “A General Classification of Three-Dimensional Flow Fields,” Physics of Fluids, 2, pp. 765–777 (1990).CrossRefGoogle Scholar
25. Lighthill, M. J., “Laminar Boundary Layers,” Oxford University Press, Cambridge, pp. 48–88 (1963).Google Scholar
26. Perry, A. E. and Steiner, T. R., “Large-Scale Vortex Structures in Turbulent Wakes Behind Bluff Bodies; Part 1: Vortex Formation,” Journal of Fluid Mechanics, 174, pp. 233–270 (1987).CrossRefGoogle Scholar
27. Hunt, J. C. R., Abell, C. J., Peterka, J. A. and Woo, H., “Kinematical Studies of the Flows Around Free or Surface-Mounted Obstacles; Applying Topology to Flow Visualization,” Journal of Fluid Mechanics, 86, pp. 299–446 (1978).CrossRefGoogle Scholar
28. Norberg, C., “Flow around Rectangular Cylinders: Pressure Forces and Wake Frequencies,” Journal of Wind Engineering and Industrial Aerodynamics, 49, pp. 187–196 (1993).CrossRefGoogle Scholar
29. Chen, J. M. and Liu, C.·–H., “Vortex Shedding and Surface Pressures on a Square Cylinder at Incidence to a Uniform Air Stream,” International Journal of Heat and Fluid Flow, 20, pp. 592–597 (1999).CrossRefGoogle Scholar
30. Knauss, D. T., John, J. E. A. and Marks, C. H., “The Vortex Frequencies of Bluff Cylinders at Low Reynolds Numbers,” Journal of Hydronautics, 10, pp. 121–126 (1976).CrossRefGoogle Scholar
31. Naudascher, E., Weske, J. R. and Fey, B., “Exploratory Study on Damping of Galloping Vibrations,” Journal of Wind Engineering and Industrial Aerodynamics, 8, pp. 211–222 (1981).CrossRefGoogle Scholar