X-ray pulsar navigation is a promising technology for autonomous spacecraft navigation. The key measurement of pulsar navigation is the time delay (phase delay). There are various methods to estimate phase delay, but most of them have high computational complexities. In this paper, a new method for phase delay estimation is proposed, which is based on the time-shift property of Discrete Fourier Transformation (DFT). With this method, the time complexity can be greatly reduced. Also, a delta-function approximation can be used to further decrease the computational cost. Numerical simulation shows that the proposed method is effective for phase delay estimation, and the reduced complexity makes our method more suitable for on board implementation.

The purpose of this paper is to discuss the safety of ship berthing operations in port. Based on the features of ship's berthing operations and relevant literature, the Safety Factors (SFs) of ship berthing at docks are first investigated. A Safety Index (SI) with a Fuzzy Analytic Hierarchy Process (AHP) model is then proposed to assess those SFs from port marine pilots, by which port managers and ship carriers may make policies to improve ship berthing safety. To validate the model, berthing operations at Kaohsiung Port in Taiwan were empirically investigated. The results indicate the main safety factors affecting ship berthing at port docks are: working concentration, the condition of mooring lines, emergency response, port policy of improving business and berth length. Based on those results, the theoretical and managerial implications for ship berthing safety at dock are finally discussed.

A significant feature of the modernised Global Navigation Satellite System (GNSS) signals is that there are multiple signal components needing to be transmitted on a carrier frequency. How to combine these signal components into a constant envelope composite signal is a challenge. Existing constant envelope modulation techniques have some limitations, and are not effective enough. To solve this problem, we propose a quasi-constant-envelope multiplexing technique in this paper. The proposed method is based on numerical optimisation, and can work in two ways. The corresponding objective functions are provided. To verify the performance of the proposed method, we present three application examples. Results show that the first variation of our method can reach the same combining performance as Phase-Optimised Constant-Envelope Transmission (POCET). In the second variation, the combining efficiency can be pre-set. We can reach higher combining efficiency than POCET, and the envelope of the composite signal becomes quasi-constant. Furthermore, the inter-modulation signals in the final composite signal are adjustable. With the help of the proposed method, we can learn more details of the combining scheme than with POCET.

Global Navigation Satellite Systems (GNSS) are used widely in the provision of Intelligent Transportation System (ITS) services. Today, there is an increasing demand on GNSS to support applications at lane level. These applications required at lane level include lane control, collision avoidance and intelligent speed assistance. In lane control, detecting irregular driving behaviour within the lane is a basic requirement for safety related lane level applications. There are two major issues involved in lane level irregular driving identification: access to high accuracy positioning and vehicle dynamic parameters, and extraction of erratic driving behaviour from this and other related information. This paper proposes an integrated algorithm for lane level irregular driving identification. Access to high accuracy positioning is enabled by GNSS and its integration with an Inertial Navigation System (INS) using filtering with precise vehicle motion models and lane information. The identification of irregular driving behaviour is achieved by algorithms developed for different types of events based on the application of a Fuzzy Inference System (FIS). The results show that decimetre level accuracy can be achieved and that different types of lane level irregular driving behaviour can be identified.

In this paper, a conventional Strapdown Inertial Navigation System (SINS) alignment method on a disturbed base is analysed. A novel method with an attitude tracking idea is proposed for the rocking base alignment. It is considered in this method that the alignment algorithm should track the rocking base attitude real changes in the alignment process, but not excessively restrain disturbance. According to this idea, a rapid alignment algorithm is devised for the rocking base. In the algorithm, coarse alignment is carried out within 30 s in the inertial frame with alignment precision less than 2°, which meets Kalman filter linearization conditions well. Then a Kalman filter with ten state vectors and four measurement vectors is applied for the fine alignment to improve the capability of the algorithm in tracking the vehicle attitude. A turntable rotation experiment is carried out to validate the capability of the fine algorithm in tracing the large magnitude change during alignment. It is shown that the repeated alignment precision is about 0·04° by the alignment experiment on a rocking vehicle, with alignment time of 180 s. The Laser Strapdown Inertial Navigation System (LINS) ground navigation experiment suggests that the algorithm proposed by this paper can be satisfied without the need of high precision SINS alignment.

We propose a novel framework for large-scale maritime ship group surveillance using spaceborne optical imaging satellite data and Electronic Intelligence (ELINT) satellite data. Considering that the size of a ship is usually less than the distance between different ships for large-scale maritime surveillance, we treat each ship as a mass point and ship groups are modelled as point sets. Motivated by the observation that ship groups performing tactical or strategic operations often have a stable topology and their attributes remain unchanged, we combine both topological features and attributive features within the framework of Dempster-Shafer (D-S) theory for coherent ship group analysis. Our method has been tested using different sets of simulated data and recorded data. Experimental results demonstrate our method is robust and efficient for large-scale maritime surveillance.

Demands on security, safety, and environmental protection in worldwide shipping are steadily increasing. Shipboard broadcast transponders based on the Automatic Identification System (AIS) can be easily detected close to coastal or waterway areas. Satellite-based AIS receivers detect globally but are limited in high-density traffic areas. This paper investigates the challenges and performance of AIS detection on aircraft at altitudes between 8 500 m and 10 000 m. During flight trials over sea and land, AIS signals were recorded. Post-processing of the recorded data allows the evaluation but also faces challenges due to the nature of overlapping AIS signals at the aircraft. A comparison of detected signals at the aircraft with received AIS signals on the ground is given, including the evaluation of the reception footprint of the aircraft. Finally, a concept for worldwide AIS detection via airliners is presented. The study shows the potential for global complementary surveillance coverage via airliner-based AIS detection.

Recently, a basic pattern of coast seaway system networking has been established in China. As a result, a large number of precautionary areas will be gradually established. Because of the high frequency of ships' encounters and accidents, these precautionary areas have been a weak but important facet of ships' routeing. Navigational Traffic Conflict Technique (NTCT) was introduced to quantitatively evaluate the safety of precautionary areas. Focusing on traffic conflict, the calculation method of navigational traffic conflict points is discussed, and a comparison analysis of the two editions (2002 and 2008) of Yangtze estuary ships’ routeing is performed. Then the automatic acquisition system of navigational traffic conflict data that can be used in the quantitative analysis of the influence degree of a single traffic flow on the whole precautionary area safety is developed, and the left-turning traffic flows of Yangtze estuary ships’ routeing precautionary areas B are taken as an example. This article establishes a foundation for the precautionary area safety analysis system, and provides the decision basis for policy making in optimisation of geometric design and traffic organisation of precautionary areas.

The use of single-receiver single-satellite data validation parameters for numerical and graphical diagnostics of the multi-frequency observations is presented. This method validates Global Navigation Satellite System (GNSS) measurements of a single receiver where data from each satellite are independently processed using a geometry-free observation model with a reparameterised form of the unknowns. The method is applicable to any GNSS with any number of frequencies. The diagnostic tools are based on checking agreement of characteristics of the validation test statistics against theory. The use of these diagnostics in static and kinematic modes is demonstrated using multiple-frequency data from three GNSS constellations; Global Positioning System (GPS), Globalnaya Navigatsionnaya Sputnikovaya Sistema (GLONASS) and Galileo.

The main routes of ships voluntarily completing meteorological observations across the North Atlantic are detected by the intensity of the geographical distribution of the voluntary ship observations. The routes are then analysed in order to assess the relative intensity of traffic, the seasonal changes and the trend over the years. This paper will provide a better understanding of the North Atlantic trades and the relationship among the different routes, allowing the identification of the busiest areas. A discussion over the impact of routing on the weather that a transoceanic ship can experience during its life is also provided.

This paper investigates the problem of how to design the distance between a mobile buoy and the target to derive maximum positioning accuracy with a Moving Long Baseline (MLBL). To that end, the positioning model and the error sources of MLBL are derived, respectively. It is assumed that the position measurement of the mobile buoy and the distance measurement between the mobile buoy and the target are corrupted by white Gaussian noises, and the variance of the distance measurement is distance-dependent. Using tools from estimation theory, the Positioning Accuracy Metric (PAM) is designed with the distance error and the position errors are considered. Based on the PAM, the optimal distance between the mobile buoy and target is deduced when the mobile buoys are in optimal geometry. Simulation examples illustrate the results.

Real-Time Kinematic (RTK) Global Positioning System (GPS) carrier phase-based precise positioning has been widely using in geodesy and surveying applications, and other high accuracy positioning and navigation applications in the last two decades. More Global Navigation Satellite Systems (GNSS) are being developed and it is usually expected that combining GNSS will have a positive impact on positioning accuracy. This paper describes a case study carried out at Ningbo in China on the impact of multi-GNSS on RTK single epoch solutions. Both GPS and GLONASS are fully operational now. Moreover, the Quasi-Zenith Satellite System (QZSS) can be observed at Ningbo. Currently, only one QZSS satellite “MICHIBIKI” is operational. This paper carries out an early assessment of the impact of QZSS on GPS and GLONASS single-epoch high precision positioning (i.e., single-epoch positioning accuracy assessment) and investigates the multipath errors in the GPS, GLONASS and QZSS multi-frequency data.

This study aims to evaluate ship collision frequency in port fairways. One case study is created using one month's real-time ship movement data from five major Singapore port fairways. Results show that tankers account for the biggest proportion in the Temasek fairway, whereas the percentage of Roll-on-Roll-Off (RORO) and passenger ships is quite small in the Temasek fairway, Sinki fairway, Jong fairway and Southern fairway. Tankers and container ships are the two major ship types involved in dangerous encounters. The largest number of dangerous head-on and overtaking encounters is located in the Jong fairway. The majority of dangerous crossing encounters have occurred in the West Keppel fairway and Jong fairway. Ship collision frequency at night is found to be significantly higher than during the day in these fairways.