Rhopalosiphum padi is an important grain pest, causing severe losses during crop production. As a systemic insecticide, flonicamid can control piercing-sucking pests efficiently. In our study, the lethal effects of flonicamid on the biological traits of R. padi were investigated via a life table approach. Flonicamid is highly efficiently toxic to R. padi, with an LC50 of 9.068 mg L−1. The adult longevity and fecundity of the R. padi F0 generation were markedly reduced under the LC25 and LC50 concentrations of flonicamid exposure. In addition, negative transgenerational effects on R. padi were observed under exposure to lethal concentrations of flonicamid, with noticeable decreases in the reproductive period, adult longevity, total longevity, and total fecundity of the F1 generation under the LC25 concentration of flonicamid. Furthermore, the third nymph stage (N3), preadult stage, duration of the adult pre-reproductive period, duration of the total pre-reproductive period, reproductive period, adult longevity, total longevity, and total fecundity of the F1 generation were significantly lower under treatment with the LC50 concentration of flonicamid. The life table parameters were subsequently analysed, revealing that the intrinsic rate of increase (rm) and the net reproductive rate (R0) were significantly lower but that the finite rate of increase (λ) and the mean generation time (T) were not significantly different under the LC25 and LC50 concentrations of flonicamid. These data are beneficial for grain aphid control and are critical for exploring the role of flonicamid in the integrated management of this key pest.

In preparation for an experiment with a laser-generated intense proton beam at the Laser Fusion Research Center at Mianyang to investigate the 11B(p,α)2α reaction, we performed a measurement at very low proton energy between 140 keV and 172 keV using the high-voltage platform at the Institute of Modern Physics, Lanzhou. The aim of the experiment was to test the ability to use CR-39 track detectors for cross-section measurements and to remeasure the cross-section of this reaction close to the first resonance using the thick target approach. We obtained the cross-section σ = 45.6 ± 12.5 mb near 156 keV. Our result confirms the feasibility of CR-39 type track detector for nuclear reaction measurement also in low-energy regions.

HMGR, 3-hydroxy-3-methylglutaryl-CoA reductase, is a major rate-limiting enzyme in mevalonate (MVA) pathway for isoprenoids and subsequent tanshinone biosynthesis in the Chinese traditional bulk herbal medicine Danshen, Salvia miltiorrhiza, mainly for cardiovascular disorders. In this paper, the genomic SmHMGR genes of 38 cultivated populations of S. miltiorrhiza collected in China were for the first time sequenced to reveal the genetic diversity and phylogeny. The SmHMGR gene was shown to be intron-free, 1650~1659 bp in complete CDS with the majority being 1656 bp, and two unique populations (W-FJLY-V-1 and W-SCHY-W-1) being 1659 and 1650 bp respectively. A total of 103 SNP variation sites were detected with a variation rate of 6.22%, most of which occurred in S. miltiorrhiza f. alba population W-SCHY-W-1; a total of 25 amino acid variation sites were found, of which 19 was in W-SCHY-W-1. The same four populations, W-SCHY-W-1, V-HBAG-V-1, V-JLCC-V-1 and S-NM-V-1 could be discriminated from the remaining 34 by both the SNP fingerprints and the deduced amino acid variation sites. Other or composite DNA markers are needed for better identification. The SmHMGR gene of white flower S. miltiorrhiza f. alba population W-SCHY-W-1 is especially rich in variations and worthy of further studies. Phylogenetic trees based on both the gene and the deduced amino acid sequences showed a very similar two-clade topological structure. This research enriched the content and the genetic means for the molecular identification, genetic diversity and phylogenetic studies of the cultivated S. miltiorrhiza populations, and laid a solid foundation for further related and in-depth investigations.

This study investigates how venture capital firms (VCs) choose syndication partners. Exponential random graph models of Chinese VC syndication networks from 2006 to 2013 show that the homophily mechanism does not always determine VCs’ partner selection. In selecting partners, VCs have to strike a balance between reducing uncertainty and mobilizing heterogeneous resources. Therefore, decisions about partners depend on institutional uncertainty and VCs’ investment preferences. While VCs that focus on traditional business in an immature market are more likely to form homogeneous syndications, their peers that prefer to invest in innovative companies and that can rely on a stable market tend to syndicate with heterogeneous partners.

Underground Nuclear Astrophysics in China (JUNA) will take the advantage of the ultra-low background in Jinping underground lab. High current accelerator with an ECR source and detectors were commissioned. JUNA plans to study directly a number of nuclear reactions important to hydrostatic stellar evolution at their relevant stellar energies. At the first period, JUNA aims at the direct measurements of 25Mg(p,γ)26 Al, 19F(p,α) 16 O, 13C(α, n) 16O and 12C(α,γ) 16O near the Gamow window. The current progress of JUNA will be given.

Babesiosis is an emerging tick-transmitted zoonosis prevalent in large parts of the world. This study was designed to determine the rates of Babesia microti infection among small rodents in Yunnan province, where human cases of babesiosis have been reported. Currently, distribution of Babesia in its endemic regions is largely unknown. In this study, we cataloged 1672 small wild rodents, comprising 4 orders, from nine areas in western Yunnan province between 2009 and 2011. Babesia microti DNA was detected by polymerase chain reaction in 4·3% (72/1672) of the rodents analyzed. The most frequently infected rodent species included Apodemus chevrieri and Niviventer fulvescens. Rodents from forests and shrublands had significantly higher Babesia infection rates. Genetic comparisons revealed that Babesia was most similar to the Kobe- and Otsu-type strains identified in Japan. A variety of rodent species might be involved in the enzootic maintenance and transmission of B. microti, supporting the need for further serological investigations in humans.

Ferroelectric random access memory (FeRAM) is believed to be the most promising candidate for the next generation non-volatile memory due to its fast access time and low power consumption. Fabrication technologies of FeRAM can be divided into two parts: CMOS technologies for circuits which are standard and can be shared with traditional IC process line, and process relating to ferroelectric which is separated with CMOS process and defined as backend module. This paper described technologies for integrating ferroelectric capacitors into standard CMOS, mainly about modeling of ferroelectric capacitors and backend fabrication technologies. Hysteresis loop of the ferroelectric capacitor is the basis for FeRAM to store data. Models to describe this characteristic are the key for the design of FeRAM. A transient behavioral ferroelectric capacitor model based on C-V relation for circuit simulation is developed. The arc tangent function is used to describe the hysteresis loop. “Negative capacitance” phenomenon at reversing points of applied voltage is analyzed and introduced to the model to describe transient behaviors of the capacitor. Compact equivalent circuits are introduced to integrate this model into HSPICE for circuit simulation. Ferroelectric materials fabrication, electrodes integration and etching are the main technologies of FeRAM fabrication process. An metal organic chemical vapor deposition (MOCVD) process is developed to fabricate high quality Pb(Zr1-xTix)O3 (PZT) films. Pt is known to cause the fatigue problems when used as electrodes with PZT. Ir is used as electrodes to improve the fatigue property of PZT based capacitors, and mechanism of the fatigue is analyzed. Hard mask is used to reduce the size of the capacitors and damage caused in etching process. In our process, Al2O3 is developed as hard mask, which simplifies the FeRAM backend integration process.

We investigated adsorption and dissociation of water and HfCl4 on a Ge/Si(100) −(2 × 1) surface with a density-functional theory. The Si–Ge and Ge–Ge homodimers are used to represent the Si1−xGex surface. (i) Water first adsorbs on the bare Ge/Si(100) − (2 × 1) surface and then dissociates into OH and H. The activation energy for adsorption of water on the Ge–Ge homodimer is much higher than that on the Si–Ge heterodimer. (ii) HfCl4 dissociates upon adsorption on the Ge/Si(100) − (2 × 1) surface into HfCl3 and Cl. No net activation barrier exists during the adsorption of HfCl4 on both SiGe surface dimers. The molecular adsorption state is found to be metastable according to the calculation, which implies that the reaction tends to move toward to the product rather than trapping in HfCl4 adsorbed state. The difference in the potential energy surface between reactions on Si–Ge and Ge–Ge dimers is due to different bond strengths.

Ultrathin polymer films have been deposited on both multi-wall and aligned carbon nanotubes using a plasma polymerization treatment. TEM experimental results showed that a thin film of polystyrene layer (several nanometers) was uniformly deposited on the surfaces of the nanotubes including inner wall surfaces of the multi-wall nanotubes. The coated multi-wall nanotubes were mixed in polymer solutions for studying the effects of plasma coating on dispersion. It was found that the dispersion of multi-wall carbon nanotubes in polystyrene composite was significantly improved. The deposition mechanisms and the effects of plasma treatment parameters are discussed.