Beta-gallium oxide (β-Ga2O3) is of increasing interest to the optoelectronic community for transparent conductor and power electronic applications. Considerable variability exists in the literature on the growth and doping of Ga2O3 films, especially as a function of growth approach, temperature, and oxygen partial pressure. Here pulsed laser deposition (PLD) was used to grow high-quality β-Ga2O3 films on (0001) sapphire and (−201) Ga2O3 single crystals and to explore the growth, stability, and dopability of these films as function of temperature and oxygen partial pressure. There is a strong temperature dependence to the phase formation, morphology, and electronic properties of β-Ga2O3 from 350 to 550 °C.

Oxygen vacancies have a significant impact on the structure and electrical/magnetic properties of doped manganites. Magnetic La0.5Sr0.5MnO3 (LSMO) films were epitaxial grown on (001) SrTiO3 substrate by pulsed laser deposition. Structural studies from the x-ray diffraction suggest that the as-grown films are fully constrained by the substrate with the thickness ranging from 8 to 40 nm. By examining the valence of Mn by x-ray photoelectron spectroscopy and x-ray absorption spectroscopy, we find the ratio of Mn4+/Mn3+ increases along with the increased film thickness, which implies that the oxygen vacancies concentration induced by tensile strain correspondingly decreases. Therefore, the magnetization of LSMO is depressed with the exchange bias effect arising, and the electrical conductivity decreases significantly. This work builds a bridge between modulation of electric/magnetic properties and epitaxial strain in LSMO films.

Transparent conductive oxides and amorphous oxide semiconductors are important materials for many modern technologies. Here, we explore the ternary indium zinc tin oxide (IZTO) using combinatorial synthesis and spatially resolved characterization. The electrical conductivity, work function, absorption onset, mechanical hardness, and elastic modulus of the optically transparent (>85%) amorphous IZTO thin films were found to be in the range of 10–2415 S/cm, 4.6–5.3 eV, 3.20–3.34 eV, 9.0–10.8 GPa, and 111–132 GPa, respectively, depending on the cation composition and the deposition conditions. This study enables control of IZTO performance over a broad range of cation compositions.

Supercapacitor has received intense interest due to its high-charge/discharge rate and high-power density. C/Fe2O3 layer with different C/Fe ratios were synthesized by a solution-based approach for supercapacitor application. The influence of synthesis conditions on their electrochemical performances was investigated. Cobalt was added into C/Fe2O3 and significant improved its performance. The optimal C/Fe2O3 sample gives a high specific capacitance of 85.3 F/g and the addition of Co3O4 further increase the capacitance of obtained C/Fe2O3/Co3O4 to 144.4 F/g at 5 A/g. This work demonstrates an efficient supercapacitor application of low-cost metal oxides and facile solution-based synthesis approach.

Among various material nanoarchitectures, the nanotube geometry has received incredible attention due to the unique properties provided by its high surface area as well as nanoscale wall thickness and the availability of a variety of techniques to fabricate them. Since the beginning of this century, anodization has emerged as one of the most effective techniques for the fabrication of functional oxide nanotubes. Oxide nanotubes of a number of metals and alloys have been developed using this versatile technique. We review here the research activities on anodic nanotubes of various binary, ternary, and multinary materials and their selected applications.

We report the effect of patterning on photoelectrochemical (PEC) water-splitting performance. Oxide–oxide heterostructures based on horizontal and vertical heterojunctions were fabricated on transparent conductive oxide glass by sequential plasma enhanced chemical vapor deposition (PECVD) of individual metal oxide. Featured masks were employed to enable three-dimensional patternings of stripes and cross-bars structures formed by Fe2O3 and TiO2 layers. PEC measurement was carried out by a three-electrode cell. It was found that double layered TiO2//Fe2O3:FTO showed a decrease in PEC performance when compared with single Fe2O3:FTO layer, whereas triple-layered Fe2O3//TiO2//Fe2O3:FTO (both patterned and unpatterned samples) displayed enhanced photocurrent density. The results show that the existence of multiple phase boundaries does not always add up to PEC enhancement observed in single heterojunction.

The origin of ionic conductivity in bulk lithium lanthanum titanate, a promising solid electrolyte for Li-ion batteries, has long been under debate, with experiments showing lower conductivity than predictions. Using first-principles-based calculations, we find that experimentally observed type I boundaries are more stable compared with the type II grain boundaries, consistent with their observed relative abundance. Grain boundary stability appears to strongly anti-correlate with the field strength as well as the spatial extent of the space charge region. Ion migration is faster along type II grain boundaries than across, consistent with recent experiments of increased conductivity when type II densities were increased.