This note is a report on the observation that the Fano–Enriques threefolds with terminal cyclic quotient singularities admit Calabi–Yau threefolds as their double coverings. We calculate the invariants of those Calabi–Yau threefolds when the Picard number is one. It turns out that all of them are new examples.

We consider the connected-sum method of constructing compact Riemannian 7-manifolds with holonomy G2 developed by the first named author. The method requires pairs of projective complex threefolds endowed with anticanonical K3 divisors and the latter K3 surfaces should satisfy a certain ‘matching condition’ intertwining on their periods and Kähler classes. Suitable examples of threefolds were previously obtained by blowing up curves in Fano threefolds.

In this paper, we give a large new class of suitable algebraic threefolds using theory of K3 surfaces with non-symplectic involution due to Nikulin. These threefolds are not obtainable from Fano threefolds as above, and admit matching pairs leading to topologically new examples of compact irreducible G2-manifolds. ‘Geography’ of the values of Betti numbers b2, b3 for the new (and previously known) examples of irreducible G2 manifolds is also discussed.

Al8B4C7 was used as a sintering additive for the densification of nano-SiC powder. The average grain size was approximately 70 nm after sintering SiC-12.5wt% Al8B4C7 at 1550 °C. The densification rate strongly depended on the sintering temperature and the applied pressure. The rearrangement of SiC particles occurred at the initial shrinkage, while viscous flow and liquid phase sintering became important at the middle and final stage of densification.

The objective of this study was to determine the effects of oviductal fluid and heparin on sperm penetration and the characteristics of spermatozoa. The addition of oviductal fluid and heparin to the fertilisation medium decreased sperm penetration and the mean number of spermatozoa in penetrated eggs. The number of spermatozoa firmly bound to zona pellucida was also decreased in the presence of oviductal fluid and heparin. Chlortetracycline (CTC) fluorescence patterns were used to determine the incidence of capacitation and the acrosome reaction. The proportion of capacitated and acrosome-free spermatozoa increased when spermatozoa were exposed for 1.5 and 3 h to oviductal fluid and heparin. In contrast heparin alone did not increase the number of capacitated spermatozoa at these time points. These results suggest that factor(s) in oviductal secretions reduce polyspermic fertilisation and the number of spermatozoa that will penetrate porcine oocytes. The reduction of polyspermic penetration by oviductal secretions may be due to a reduced number of spermatozoa in the fertilisation medium with an intact acrosome.

The objective of this study was to determine developmental pattern and cell allocation to the inner cell mass and trophectoderm in haploid and diploid embryos following parthenogenetic activation. In vitro matured porcine oocytes were activated by ethanol treatment and cultured in the presence or absence of cytochalasin B for 5h. The oocytes were then cultured in the NCSU23 for 9 days. The combined treatment with cytochalasin B following ethanol treatment did not increase (p >0.1) the incidence of activation. The incidence of development to the blastocyst stage was higher (p <0.05) in the combined treatments of ethanol and cytochalasin B as compared with ethanol treatment alone. The percentage of oocytes with two female pronuclei was higher (p < 0.01) in oocytes treated with cytochalasin B than that in ethanol treatment alone. Treatment with both ethanol and cytochalasin B increased (p <0.01) the incidence of diploid chromosome spread over just the ethanol treatment alone. The average numbers of total cells and inner cell mass were significantly reduced (p <0.05) in the ethanol treatment alone as compared with the combined cytochalasin B and ethanol treatment. These results suggested that the ploidy may affect blastocoele formation and cell allocation to inner cell mass and trophectoderm in the pig.

In this study we imaged integral changes in microfilament assembly and cortical granule distribution, and examined effects of microfilament inhibitor on the cortical granule distribution during oocyte maturation, parthenogenetic activation and in vitro fertilisation in the pig. The microfilament assembly and cortical granule distribution were imaged with fluorescent-labelled lectin and rhodamine-labelled phalloidin under laser scanning confocal microscopy. At the germinal vesicle stage, cortical granule organelles were located around the cell cortex and were present as a relatively wide area on the oolemma. Microfilaments were also observed in a wide uniform area around the cell cortex. Following germinal vesicle breakdown, microfilaments concentrated in the condensed chromatin and cortical granules were observed in the cortex. Treatment with cytochalasin B inhibited microfilament polymerisation and prevented movement of cortical granules to the cortex. Cortical granule exudation following sperm penetration was evenly distributed in the entire perivitelline space. These results suggest that the microfilament assembly is involved in the distribution, movement and exocytosis of cortical granules during maturation and fertilisation.

To determine the effectiveness of infection control strategies to reduce transmission of vancomycin-resistant enterococci (VRE), a cohort study was performed in a university hospital. Contact precautions alone were not effective in reducing transmission of VRE. Strict isolation of affected patients in private rooms, in addition to use of contact precautions, showed a significantly improved reduction in the transmission of VRE.

An asymmetric dual gate poly-Si thin film transistors (TFTs), which is consist a long-gate TFT and a short-gate TFT, were fabricated in order to suppress the kink current and increase the reliability. The long-gate TFT operates in a linear regime and limits the total current flow by its current operation region. The asymmetric dual-gate does not exhibit from the kink current in a high drain bias due to the distribution of lateral electric field. The asymmetric dual-gate structure improves kink-free characteristics compared with conventional single and dual-gate TFTs. The hot-carrier stress reliability is successfully improved due to kink current suppression.

In a crystallographic study of stress induced voiding of copper interconnect, the planar electron backscattered diffraction analysis showed that the void was initiated at the triple junction of the grain boundaries, not at the junction of the twin boundary and grain boundary. By using stepwise cross-sectional crystalline investigation for the void, it was possible to rebuild 3D crystalline structure near the void. From the stress calculation based on the measured crystalline structures, the hydrostatic stress was highly concentrated at the triple junction of the twin boundary and grain boundary, but experimentally, there was no voiding at that. The voiding in the copper interconnect may depend mainly on the boundary instability.

We report the characterization of white light emitting devices fabricated using conjugated polymer blends. Blue emissive poly[9,9-bis(4′-n-octyloxyphenyl)fluorene-2,7-diyl-co-10-(2′-ethylhexyl)phenothiazine-3,7-diyl] [poly(BOPF-co-PTZ)] and red emissive poly(2-(2′-ethylhexyloxy)-5-methoxy-1,4-phenylenevinylene) (MEH-PPV) were used in the blends. The inefficient energy transfer between these blue and red light emitting polymers (previously deduced from the photoluminscence (PL) spectra of the blend films) enables the production of white light emission through control of the blend ratio. The PL and electroluminescence (EL) emission spectra of the blend systems were found to vary with the blend ratio. The EL devices were fabricated in the indium tin oxide [poly(3,4-ethylenedioxy-thiophene)-poly(styrenesulfonate)] (ITO/PEDOT-PSS)blend/LiF/Al configuration, and white light emission was obtained for one of the tested blend ratios.

We propose a short channel gate overlapped lightly doped drain (GOLDD) poly-Si TFT employing 45° tilt implant for source and drain (S/D) regions without any additional ion doping or mask. Oblique-incident ELA activation is performed to activate both n+ S/D and n- LDD regions as well as cure junction defects. The proposed poly-Si TFT can suppress the anomalous leakage current, and exhibit the better reliability against the hot-carrier stress.

Incomplete reprogramming of the donor cell nucleus after nuclear transfer (NT) probably leads to the abnormal expression of developmentally important genes. This may be responsible for the low efficiency of cloned animal production. Insulin-like growth factor 2 (IGF2) and IGF2 receptor (IGF2R) are imprinted genes that play important roles in preimplantation development. To obtain an insight into abnormal gene expression after nuclear transfer, we assessed the transcription patterns of IGF2-IGF2R in single in vitro fertilised and cloned embryos by reverse-transcription polymerase chain reaction (RT-PCR). IGF2R expression did not differ significantly but IGF2 was more highly expressed in cloned embryos than in IVF embryos (p < 0.05). This was confirmed by a quantitative RT-PCR method. Thus, incomplete reprogramming may induce abnormal transcription of IGF2 in cloned embryos.

For a diffusion barrier against Cu, tantalum nitride (TaN) films have been successfully deposited by both conventional thermal atomic layer deposition (ALD) and plasma assisted atomic layer deposition (PAALD), using pentakis (ethylmethlyamino) tantalum (PEMAT) and ammonia (NH3) as precursors. The growth rate of PAALD TaN at substrate temperature 250° was slightly higher than that of ALD TaN (0.80 Å/cycle for PAALD and 0.75 Å/cycle for ALD). Density of TaN films deposited by PAALD was as high as 11.0 g/cm3, considerably higher compared to the value of 8.3 g/cm3 obtained by ALD. The N: Ta ratio for ALD TaN was 44: 37 in composition and the film contained approximately 8∼10 atomic % carbon and 11 atomic % oxygen impurities. On the other hand, the ratio for PAALD TaN layers was 47: 44 and the respective carbon and oxygen contents of TaN layers decreased to 3 atomic % and 4 atomic %. The stability of 10 nm-thick TaN films as a Cu diffusion barrier was tested through thermal annealing for 30 minutes in N2 ambient and characterized by XRD, which proves the PAALD deposited TaN film to maintain better barrier properties against Cu below 800°.

A new self-aligned poly-Si TFT has been fabricated by employing a photoresist backside exposure technique. A pre-patterned aluminum (Al) layer on a-Si film not only induces the lateral grain growth (∼1.6 μm) in excimer laser crystallization but also implements the selfalignment of the gate region with the lateral grain region. Photoresist backside exposure through poly-Si film has been successfully performed because crystallized poly-Si has a fairly high UV transmittance. A self-aligned poly-Si TFT with a single grain boundary within the 2 μm channel was successfully fabricated and high on/off current ratio (∼107) was obtained.